Getting Started; Batteries; Change Settings; Table Stand Or Wall Mount - Oregon Scientific BAR626 Manual De Uso

GETTING STARTED

BATTERIES

Batteries are supplied with this product:
Main unit 3 x UM-3 (AA) 1.5V batteries
Remote unit 2 x UM-4 (AAA) 1.5V batteries
Insert batteries before first use, matching the polarity (+
and -) as shown in the battery compartment. For best
results, install batteries in the remote sensor before the
main unit. Press RESET after each battery change.
NOTE Do not use rechargeable batteries.
shows when batteries are low.
NOTE It is recommended that you use alkaline
batteries with this product for longer performance.
Installing the batteries:
UNIT LOCATION
Main Indoor Temperature Area
Remote Outdoor Temperature Area

CHANGE SETTINGS

To change, time, calendar and language settings:
1. Press and hold MODE for 2 seconds to enter
setting mode.
2. Press or to change settings. (To reach the
setting you want quickly, press and hold
3. Press MODE to confirm.

TABLE STAND OR WALL MOUNT

Use the stand on the back of the main unit / remote
sensor, or mount it on a wall with a nail.
Attaching the stand:
Using the wall mount:
Using the remote sensor stand or wall mount:
4
or .)