Safety Valve; Protective Device - Senco PC1286EU Instrucciones De Operación

3. After adjusting the supply pressure, connect an air
house to an air outlet (air chuck). Now, you are ready
to start operating the machine.
4. Connect a High Pressure Nailer High Pressure Hose
to the special air fitting on the part of the reducing
valve H. Connect a general nail driver air hose to the
air chunk on the part of the reducing valve L.
● Connection to the female fitting is made by simply
pressing an male fitting into it.
WARNING
Prior to connecting the air hose to the machine, be sure
to check that air house and house fitting have been com-
pletely secured.

SAFETY VALVE

The Safety Valve is designed to prevent system failures by
relieving pressure from the system when the compressed
air reaches a predetermined level. The Safety valve is pre-
set by the manufacturer and must
not be modified and adjusted in any way.

PROTECTIVE DEVICE

If there is a considerable voltage drop or an abnormality
inside the machine at the time of operation, a motor burnout
preventive thermal protector may be activated
to stop the motor. If this is the case:
1. Turn off the Power switch and disconnect the power
plug from the plug socket.
2. Check whether a circuit breaker of 220/230 V AC/ 10A
or 110V/120V AC or higher current capacity is used,
whether the extension cord is reasonably long, neither
tool long nor tool fine, or whether or not the identical
power source is also used for other electric tool. etc.
If so, stop using the extension cord or electric tool.
WARNING
When using the extension cord or drum cord, be sure to
use those of "1.5mm 2 or thicker and up to 20 m long." in
the fully stretched condition.
● In order to prevent a voltage drop due to use of the
extension cord, connect the machine directly to the
main power source, avoiding use of the extension
cord as much as possible.
● When the main power source is of less than 230 V or
when other electric tool is used simultaneously, the
voltage will drop more.
● The power breaker may be activated, if other electric tool
is used on the identical power source and the current
consumption value exceeds the current capacity of the
power breaker. If this is the case, avoid combined use
with the electric tool on the identical power source.
3. Connect the power plug to the electric outlet socket and
turn on the power switch to restart operation.
● Unless the motor is fully cooled down, the protective
may be reactivated immediately, even if the machine
is run again. Also, the machine may not run if the power
switch is turned on. If this is the case, cool it down
naturally for about 30 minutes.
4. If the protective device is activated despite that nothing
is wrong with the power source or wiring, the machine
is possibly out of order. Contact our nearest distributor or
Manufacturer SERVICE for inspection/repairing.
9