Activate Alarm; Snooze; Barometer; View Barometer Area - Oregon Scientific BAR989HG Manual De Usuario

ACTIVATE ALARM

Navigate to the Clock Area, then press ALARM /
switch to Daily Alarm or Pre-Alarm view. To activate or
deactivate the alarm, press UP or DOWN.
When the alarm time is reached, the backlight will be on
for 8 seconds and crescendo alarm will sound for
2 minutes. Press any key (except snooze) to silence
the alarm. It will sound at the same time the next day.

SNOOZE

Press SNOOZE / LIGHT to temporarily disable the alarm
for 8 minutes. or will blink while snooze is on.

BAROMETER

This product tracks fluctuations in barometric pressure
to provide the weather forecast, and the current and past
24 hours barometric pressure history measurements are
recorded by the main (indoor) unit.

VIEW BAROMETER AREA

Press SELECT to navigate to the Barometer Area.
If is NOT shown, press MODE.
BAR989HG_M_EN_op.p65
Barometric data is shown in 2 areas at the bottom of the
display. The upper area shows a 24-hour bar chart.
to
The lower area shows current and historical readings.

SELECT MEASUREMENT UNIT

Slide the mb / inHg switch (in the clock battery
compartment), to change the display unit.

VIEW BAROMETER HISTORY

Navigate to the Barometer Area. Then press HISTORY
repeatedly to scroll through the measurements. The
number shown in the HR box indicates how long ago
each measurement was taken (e.g. 2 hours ago, 3 hours
ago, etc.).
18
18 2005.9.17, 10:29 AM