Transport; Storage - AL-KO EKS 2000/35 Manual De Instrucciones

Transport

Malfunction
Motor does not run.
The guide rail and saw chain
become hot when running,
smoke development. No sup-
ply of saw chain oil.
Engine running, but the saw
chain does not move.
Only sawdust is thrown out,
rather than wood chips. The
chain saw has to be pushed
through the wood.
Appliance vibrates unusually.
10 TRANSPORT
WARNING! Danger of fatal injury and
danger of extremely severe injury. During
transport, a running saw chain can lead to ex-
tremely serious and even fatal injury.
■
Never carry and transport the chain saw with
the saw chain running.
Before transporting, carry out the following mea-
sures:
1. Switch off the chain saw and disconnect the
mains plug.
2. Fit the chain guard.
3. Carry the chain saw only at the bow handle.
Guide rail and saw chain should be facing to
the rear.
440105_f
Cause
No mains power.
Overload protection has
switched off.
Chain brake engaged.
The saw chain is tensioned
too tightly.
Oil tank is empty.
The oil entry hole and/or
groove of the guide rail are
dirty.
The saw chain is tensioned
too tightly.
The chain brake bracket is
pushed forwards.
Appliance errors
The saw chain is blunt.
Appliance errors
4. In vehicles: Secure the chain saw against tip-

11 STORAGE

Thoroughly clean the chain saw after each use.
Store it in a dry, lockable place out of the reach of
children.
Carry out the following jobs before intervals in
work lasting for longer than 30 days:
1. Switch off the chain saw and disconnect the
2. Empty the oil tank for the saw chain oil.
3. Remove the saw chain and guide rail, clean it
4. Thoroughly clean the chain saw and store it
Remedy
■
Check the extension cable; use
a new one, if necessary.
■
Check fuses / RCCB.
■
Have the power supply checked
by a qualified electrician.
Wart until the overload protection re-
establishes the power supply.
Release the chain brake.
Reduce chain tension.
■
Replenish the saw chain oil.
■
Inspect the oil tank for damage
Clean the oil entry hole and groove
of the guide rail.
Reduce chain tension.
Pull the chain brake bracket towards
the bow handle.
Contact an AL-KO service centre.
Sharpen the saw chain or contact an
AL-KO service centre.
Contact an AL-KO service centre.
ping over, damage and leakage of chain oil.
mains plug.
and spray it with rust-proofing oil.
in a dry place.
47