Overmax X-bee fold one Manual De Usuario página 31

return will be initiated automatically when the remote control loses connection with the drone
for more than 6 seconds. You can regain control over the drone if the remote control regains
connection and you press the return key.
NOTE:
•
During emergency return, you cannot control the drone to avoid obstacles.
•
The drone will not return to the starting point if the GPS signal is weak (fewer than 7 satellites).
•
If during the smart return the user wants to raise the drone to the altitude of 15 m or more, the
drone will stop rising and will initiate the emergency return procedure instantly.
•
If the GPS signal is not good at the takeoff (fewer than 7 satellites), and the drone loses
connection with the remote control for more than 6 seconds, the drone will drop slowly and
will block after landing.
3. Low-battery return
This mode activates when the drone battery is flat, and it affects its ability to return to the
spot marked as "home".
•
When LEDs of the drone flash fast, the battery status shows flat battery (
control emits short signals and the drone is above the height of 30 meters or at a distance of
more than 100 meters from the remote, the drone will return to the starting point automatically.
During the return arising from low battery, if the distance is up to 100 meters, you can cancel
the return by clicking the return to home key.
•
When the drone's LEDs blink quickly, the battery charge indicator shows the battery is low (
), the remote control emits short signals and the drone is at the height of more than 15
meters or at a distance of more than 15 meters from the remote, the drone will return to the
starting point automatically. If the drone is closer or lower (15m high or 15 m of distance), it
will drop and land on the ground.
During the return arising from flat battery, you cannot regain control when clicking
the return function key.
How to charge battery
See: fig. 4.
A – battery
See: fig. 5
1.
Insert the battery into the charging station.
2.
Connect the USB cable to the USB power adapter (adapter not supplied).
3.
Connect the second tip to the charging station with battery.
4.
Plug the feeder cable in the socket
power adapter USB 5 V ⎓ 2 A (not supplied). The use of other power adapters may affect the
Fully charge the battery before you use the drone. Use the USB cable supplied only. Use the
product charging time. Full charging of the recommended adapter takes about 2,5 hours.
B – battery charging station
EN
), the remote