Overmax X-bee fold one Manual De Usuario página 35

The drone has two control modes which switch left and right bars. By default the mode 2
is active.
A – Fly forward or backward
B – Turn left or right
C – Throttle
D – Fly left or right
To change the mode:
1.
Press the lock key (3)
2.
Press and hold the return-to-home key for about 3 seconds
mode 1 and 2. The selected mode is displayed on the LCD screen. Every time you press
and hold, you change the mode.
By default the product works in the mode 2. To change the mode, the controller must be
connected to the drone.
Quick return to home (RTH)
Press the return-to-home key (fig. 12). The controller will emit a sound to signal that the
function has been activated. The drone will return to the spot marked as "home". If you press
this key once more, the return will be cancelled.
How to connect the remote control to the drone
Press and hold the lock key
(see: fig. 15). The controller will emit two sounds and the signal indicator on LCD screen will
start flashing. It will mean that the controller is ready for the pairing procedure.
Switch the drone on. It will emit a sound and connect to the controller automatically. The
controller will emit a sound and the signal indicator on LCD screen will stop flashing – it will
mean the end of the pairing procedure.
It is possible to connect the remote control to the drone only if the controller is not connected
to any other drone. If there are a few kinds of drone and controllers in one place, the pairing
procedure must be performed one by one for each set to avoid wrong pairing.
Detection mode
After connecting to the remote control, the drone enters detection mode. Drone LEDs will flash
alternately in red, green and yellow. Make sure the drone stands on the flat and horizontal
surface at this time. The procedure takes about 8 seconds. When the procedure is finished,
the drone will switch into compass calibration mode.
Note! If the drone is unable to finish this stage and cannot switch into compass calibration
mode on its own, put it on the floor and try to call the gyroscope calibration mode.
and activate the controller by sliding the on/off switch.
and then activate the controller by sliding the on/off switch
to choose between
EN