Overmax X-bee fold one Manual De Usuario página 33

B – Assembly of the propeller rotating in an anti-clockwise manner
Assemble the propeller marked as "B" on the relevant motor. Tighten up two screws with the
use of screwdriver in a clockwise manner (fig. 6a).
EN
How to disassemble propellers
Use a screwdriver to unscrew two screws which hold the propeller and remove them from the
motor (fig. 6b).
Be careful during the assembly. Propellers have sharp edges, there is an injury risk. If the assembly
is improper, the product will not fly properly and may get damaged. Please pay special attention
to marking of propellers and their target position on the drone. Use propellers from the set
or purchased directly from the manufacturer only. Do not touch moving/rotating propellers.
Before you use the drone, make sure the assembly of propellers is correct and stable. Do not
use propellers if they are damaged.
LCD display icons (fig. 8)
A – Return to home icon (RTH mode)
This icon will be visible until the drone returns to the specific spot.
B – Drone battery status
Shows drone battery status.
C – Distance from home
The indicator shows distance between the drone and spot marked as "home".
D – Height from home
The indicator shows height between the drone and spot marked as "home".
E – GPS
ON – GPS mode enabled
OFF – GPS mode disabled
F – Number of GPS satellites
As soon as the drone connects with the sufficient number of satellites (at least 7), the starting
point of the drone will save in the memory as "home".
G – Drone working mode
After the device has started, the product enters the working mode "mode 2" by default.
H – Speed mode
The indicator of the selected drone flight speed mode – HIGH (high speed) or LOW (low speed).
I – Photo/video
After taking a photo, the camera icon will glow on the screen for a while. When recording
a video, this icon will flash until the end of the recording.