Using The Ac Adaptor; Battery Indicator - JVC XL-PG37SL Instrucciones De Funcionamiento

A
@
=
>
B
8
?
A
Power Supply
Preparations

Using the AC adaptor

Connect the AC adaptor supplied.
a DC IN jack (DC IN 4.5 V
b Right side panel of the unit
c AC adaptor
d AC power outlet
Note:
The unit is in the standby condition when the AC adap-
tor is connected. The primary circuit is always "live" as
long as the AC adaptor is connected to an electrical
outlet.
Using the car adaptor
The XL-PV370SL come with a car adaptor.
For XL-PG37SL and XL-PG57SL, obtain the optional car
adaptor as required.
• Car adaptor (CA-R456 or CA-R457)
The car adaptor can be used to recharge the unit's bat-
teries while in a car.
Using dry-cell batteries
(not included)
After disconnecting the AC adaptor, insert two "R6" (LR-
6) alkaline batteries.
The procedure for inserting and removing dry-cell
batteries is identical to that for rechargeable batter-
ies.

Battery indicator

e Battery indicator
This indicator flashes on and off when the batteries are
almost out of power. Power is cut off completely a short
while later.
Rechargeable batteries: Recharge batteries.
Dry-cell batteries: Replace batteries with new ones.
Notes:
• The length of time the unit can continue further opera-
tion after the battery indicator starts flashing differs
depending on the type of batteries used.
• The battery indicator may not flash if rechargeable batter-
ies, other than those designated by JVC, are used.
Tip:
Turning off the Anti-Shock Protection EX will save the
battery power more or less. For details, see "Anti-Shock
Protection EX" on page 22.
If the unit malfunctions or freezes during use,
disconnect the power source (the AC adaptor
and batteries) once. Then, re-connect the power
source and continue operation.
)