GM 19158581 Guia De Inicio Rapido

Roof Crossrails
Contents
Crossrail – Front
Crossrail – Rear
Instruction Sheet
Screw – Access Cover
Wrench – T-25
Access Cover (Right Hand - Front)
Access Cover (Left Hand - Front)
Access Cover (Right Hand - Rear)
Access Cover (Left Hand - Rear)
Tools Required
M6 Torx Head Screw Driver
NOTE: When the crossrails are not in use, place the crossrails
at the following positions for windnoise reduction. Place rear
crossrail at the rear most point of the vehicle and the front
crossrail above the opening of the rear door.
NOTE: If access cover and screw are in place remove cover
prior to lifting the crossrail lever which releases the clamp.
Failure to do this could result in damage to the crossrail
assembly.
Installation Procedure
1. Remove production crossrails, if equipped.
2. Lift lever to open clamp on both ends of the crossrails.
FIGURE 1
Roof Crossrails
ALL INFORMATION WITHIN ABOVE
DATE
BORDER TO BE PRINTED EX-
ACTLY AS SHOWN ON 8.5 x 11 10MR06
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
Quantity
1
1
1
4
1
1
1
1
1
REVISION
I
3. Position crossrail assembly between vehicle side rails so
that the rail passes through the clamp.
FIGURE 2
4. Pull lever down to close clamp around the side rail. Pull and
press lever until it is flush with the upper support of the
clamp.
FIGURE 3
5. Slide access cover into position into the upper support of
the clamp. With the cover locked into position, insert torx
screw through cover and into the support.
FIGURE 4
6. Tighten screw with torx head screw driver.
FIGURE 5
PART
IR 10MR06
NO.
INSTALLATION INSTRUCTIONS
AUTH D R
TITLE
PART NO.
19158581
6200 Grand Pointe Dr., Grand Blanc, MI 48439
19158581
SHEET
Roof Crossrails
1
SHEET
1 3
OF
3
OF