3M G22C Manual De Instrucciones página 72

An
3M™ Peltor™ G22C/G22D Helmet
INTENDED USE
This product meets the requirements of
AS/NZS1801:1997 Occupational Protectve Helmets. This
product also meets the optional performance
requirements for lateral deformation, molten metal splash
and very low temperatures (-30°C). This product is
designed to protect the wearer against objects likely to
strike the head. See all instructions for use and save for
continuing reference.
^ Particular attention should be given to warning
statements where indicated.
^
WARNINGS
• Always be sure that the complete product is:
- Suitable for the application;
- Fitted correctly;
- Worn during all periods of exposure;
- Replaced when necessary.
• Proper selection, training, use and appropriate
maintenance are essential in order for the product to
help protect the wearer from impact hazards.
• Failure to follow all instructions on the use of these
personal protection products and/or failure to
properly wear the complete product during all periods
of exposure may adversely affect the wearer's health,
lead to severe or life threatening illness or permanent
disability.
• For suitability and proper use follow local regulations,
refer to all information supplied or contact an
occupational hygienist, safety professional or 3M
representative on the Tech Assist Helpline 3M
Australia 1800 024 464, 3M New Zealand 0800 364
357.
• Never alter or modify this product, unless
recommended by the manufacturer.
• For adequate protection this helmet must fit or be
adjusted to the size of the users head.
• The helmet is made to absorb the energy of a blow
by partial destruction or damage to the shell and the
harness, and even though such damage may not be
readily apparent, any helmet subjected to severe
impact should be replaced.
• The attention of users is also drawn to the danger of
modifying or removing any of the original component
parts of the helmet, other than as recommended by
the helmet manufacturer. Helmets should not be
adapted for the purpose of fitting attachments in any
way not recommended by the helmet manufacturer.
• Do not apply paint, solvents, adhesives or
self-adhesive labels to the helmet. If it is important to
stick anything to the helmet, only use rubber or
acrylic based adhesives.
• Direct contact with sprays, fluids or other substances
containing solvents and/or alcohols can reduce the
durability of the helmet and should therefore be
avoided.
• Use of the helmet should be kept within industrial
areas only and the helmet should not be used in any
other application such as horse riding or bike riding.
• Always ensure that the head harness is well
maintained and correctly adjusted to the users head.
If in doubt contact your safety officer or 3M for further
advice.
PREPARATION FOR USE
Inspection
Ensure that the head harness is always attached to the
helmet at the appropriate points and securely fitted to the
head before it is worn.
Before each use the helmet should be inspected for
cracks, cuts or other damage and should be rejected and
disposed of if these are discovered.
Fitting
For adequate protection the helmet must fit or be adjusted
to the size of the users head.
Insert the 3 harness holders into the helmet grooves (See
figure 1).
^ It is important that the headbands are properly
tensioned in their attachments.
Helmet adjustment
Adjust the nape strap to fit the wearers head correctly.
Once the nape strap has been tightened so that the
helmet sits securely, press the studs into the holes.
The height of the head harness can be set at a choice of
3 vertical height settings for optimum comfort (See figure
2).
70