ProKlima 20802426 Manual De Instrucciones página 11

GB
PARTS DESCRIPTION
1. Front guard
2. Blade
3. Fixation screws for rear guard
4. Rear guard
5. Handle
6. Grill locking screw
7. Blade fastening screw
8. Motor shaft
9. Motor unit
10. Oscillation knob
11. Speed control switch
12. Connecting screws
13. Base
ASSEMBLY INSTRUCTIONS
1. Rear guard assembly
Fit the rear guard (4) onto motor with the handle on the top. Tighten the rear guard with 4 fixation screws

(3).
2. Fan blade assembly
Install fan blade (2) onto motor shaft (8) and use the blade fastening screw (7) to fix the blade.

3. Front guard assembly
Put the hook of the front guard (1) onto the top of rear guard.

Attach front guard to rear guard, use the grill locking screw (6) to fasten the two grilles together and close

all clips.
OPERATING INSTRUCTIONS
1. Plug the power cord into a suitable socket.
2. Oscillation: To make the fan head oscillate, push down the oscillation knob. To stop the fan head from
oscillating, pull up the oscillation knob.
3. Tilting Angle: you can adjust the fan to the preferred elevation by loosening the connecting screws. Tighten
the connecting screws after the adjustment of tilt angle.
4. The fan is switched on by using the speed control switch on the rear shell (near the oscillation button), i.e.
0: Off, I = low speed, II = medium speed, III = high speed.
CLEANING
1. Before servicing the fan and after each occasion of use, switch off the appliance and unplug the mains cable
from the socket.
2. Never immerse the appliance in water (danger of short-circuit). To clean the appliance, only wipe it down
with a damp cloth and dry it carefully. Always take out the mains plug first.
3. Take care that excessive dust does not build up in the air-intake and air-outlet grille, and clean it occasionally
using a dry brush or vacuum cleaner.
- 10 -