For Movement And Maintenance - Mitsubishi Electric MCFH-A24WV Manual De Instalación

7. FOR MOVEMENT AND MAINTENANCE

7-1 FRONT PANEL REMOVAL
1. Remove front grill.
• Remove 3 screws. (See to 4-1-(4)) (Page 5).
2. Remove front panel.
• Remove 10 screws as shown in the right.
• Unlock front panel by pulling it toward yourself (1) and then
pull it down as the arrow (2).
• After removing the front panel, it is possible to service many
parts.
7-2 GAS CHARGE
1. Connect gas cylinder to the service port of stop valve (3-way).
2. Execute air purge of the pipe (or hose) coming from refrigerant gas cylinder.
3. Replenish specified amount of the refrigerant, while operating the air conditioner for cooling.
Note:
In case of adding refrigerant, comply with the quantity specified for the refrigerating cycle.
Caution:
• Do not discharge the refrigerant into the atmosphere.
Take care not to discharge refrigerant into the atmosphere during installation, reinstallation, or re-
pairs to the refrigerant circuit.
• For additional charging, charge the refrigerant from liquid phase of the gas cylinder.
If the refrigerant is charged from the gas phase, composition change may occur in the refrigerant
inside the cylinder and the outdoor unit. In this case, ability of the refrigerating cycle decreases or
normal operation can be impossible. However, charging the liquid refrigerant all at once may cause
the compressor to be locked. Thus, charge the refrigerant slowly.
To maintain the high pressure of the gas cylinder, warm the gas cylinder with warm water (under 40°C) during
cold season. But never use naked fire or steam.
Indoor unit
Refrigerant gas
cylinder operat-
ing valve
2
Front panel
Union
Stop valve
Liquid pipe
Gas pipe Outdoor unit
Service port
Gauge manifold
valve (for R410A)
Charge hose (for R410A)
Refrigerant gas cylinder for
R410A with siphon
Refrigerant (liquid)
Electronic scale for refrig-
erant charging
Lock
1
13