Motorola Solutions IMPRES NNTN7584 Guia Del Usuario página 11

68009268001_DUC_EN.book Page 9 Wednesday, December 30, 2015 2:26 PM
The combination of the features listed above are unique in a desktop
charger. Therefore, operation of the radio with a battery attached while
in the charger is not recommended.
During the charging process, radio operation may result in minimally
reduced radio performance and extended battery charge time.
During the Reconditioning/Calibration process, the battery becomes
fully discharged. As a result, the radio may shut down during
Reconditioning/Calibration mode.
When troubleshooting, always observe the color of the LED.
Problem
No charger 1a. Poor connection between
indication
1b. No power to the charger.
Blinking Red 2a. Charger contact is not
Indication
2b. Battery is not chargeable.
Table 2. Troubleshooting
What it means...
battery and charger.
being made.
9
What to do...
1a. Remove and reinsert the battery
into the charger. If this does not
resolve the problem, then
remove power from the charger
and, using a clean dry cloth,
clean the contacts of both the
battery and the charger.
1b. Make sure that the power cord is
securely plugged into the charg-
er and an appropriate AC outlet,
and that there is power to the
outlet.
2a. Remove the battery from the
charger and replace it back into
the charger.
2b. Verify that the battery is a
Motorola-authorized battery
listed in Table 4 . Other batteries
may not charge.
Remove power from the battery
charger and, using a clean dry
cloth, clean the gold metal
charging contacts of both the
battery and the charger.
Replace battery.