Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 27
6
Operation
● Plug in the appliance and place on the
heat­resistant storage bag.
● To switch on, hold down the ON/OFF
switch 1 for about 1 second. The preset
temperature (150°C) lights up on the dis­
play 3.
● The desired temperature can now be set
using the temperature selector 2 at inter­
vals of 10 between 120°C and 200°C:
– up to 140°C for fine, straight hair
– approx. 180°C for normal, wavy hair
– from 180°C for strong, curly hair.
Tip: Reduce the temperature for dam­
aged hair (the ideal temperature is ap­
prox. 140°C) to protect it.
● The appliance heats up. Once the re­
quired temperature has been reached,
READY appears on the display.
Note: To switch off, hold down the ON/OFF
switch 1 for about 1 second.
Use
Risk of burns!
Never allow appliance to come into
contact with skin (scalp or ears).
With the volume styler, more volume can be
achieved at the hair root. The hair is waved
at the root, naturally giving it more lift.
● Only use the appliance on dry hair.
Note: Extensive use can damage the hair.
The even heat emission of the heating
plates is especially gentle on the hair.
Styling your hair (Figures a, b and c)
The appliance is suitable for both long and
short hair.
● Comb the hair and section it into even
strands (about 2 cm wide).
● Starting from the roots, place a strand of
hair between the plates.
Robert Bosch Hausgeräte GmbH
● Press the plates together and hold to­
gether for approximately 2 seconds.
● Treat all strands in the same manner.
● Leave the top layer of hair straight to
cover the treated strands.
● Allow hair to cool completely before
styling.
Important: Never apply in one place for
longer than 2 seconds.

Automatic shut-off

For safety reasons this appliance is
equipped with a two­stage automatic shut­
off function.
● The appliance switches automatically to
stand­by mode approximately 40 minutes
after it was switched on or after the tem­
perature selector was adjusted for the last
time. The display only shows READY.
● The appliance switches off completely if
no button is pressed within approximately
15 minutes of the appliance switching to
stand­by mode. The display will go dark.
Note: To switch the appliance back on from
stand­by mode, press either the ON/OFF
switch 1 or the temperature selector 2. The
appliance will start to heat up once again.
If the appliance has switched off completely,
the ON/OFF switch 1 must be used to
switch it back on.
en
de

Publicidad

Tabla de contenido
loading

Tabla de contenido