GM 12669900 Instrucciones De Instalación

Accessory Engine Cover Installation
Application Part Number
LTG 4 Cylinder 12663899, 12663900, 12663901
LGX 6 Cylinder 12663903, 12663904, 12663905
LT1 8 Cylinder 12669894, 12669895, 12669896
LTG – remove oil fill cap (1) then remove attaching screw (2).
Lift up cover (3). Reinstall screw at 9 N·m (80 lb in)
LGX - Remove oil fill cap and lift cover to remove. Engage rear
attaching clips when reinstalling and reinstall oil fill cap.
Camaro Accessory Engine Cover Instructions
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11 13AP15
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GM SPECIFICATIONS.
REVISION
Initial Release - Thomas Wysocki
LT1 - Remove Left and Right side cover by pulling upwards and
disengaging the grommets from the studs.
Remove 4 intake manifold cover studs and then unplug MAP
sensor and wiring harness attachments.
Remove intake manifold cover.
Install accessory intake manifold cover and reinstall intake
manifold cover studs and tighten to 10 NM (89 lb-in) and
reattach MAP sensor and wiring harness attachments.
Install accessory left hand and right hand covers by pressing
onto ball studs
IR 13AP15
INSTALLATION INSTRUCTIONS
AUTH DR
TITLE
Camaro Accessory Engine Cover Instructions
2086474
12669900
PART NO.
12669900
PART NO.
SHEET
1 3
SHEET OF
1 3
OF