GM 19169818 Manual De Instrucciones

Back Rack / Divider & Overhead Rack
NOTE: This Overhead Rack System requires the use of an auxillary Center High Mounted
Stop Lamp (CHMSL). Reference Service Bulletin at the GM Dealer for details.
Kit Contents
Number Part Name
1 Rack/Divider Assembly
2 Pivot Mount A
3 Pivot Mount B
4 Slide Mount Asm A 'with saftey pin'
5 Slide Mount Asm B
6 M8 Flat Head Cap Screw
7 M8 Flange Nut
8 Rack Knob
9 10mm Flat Washer
Tools Required
4mm Hex Driver , 5mm Hex Driver, T25 Torx Driver
1. Remove Slide Mount Slide: remove 6mm button head screw and
Slide Mount End Cap to allow removal of plastic Slide Mount
Slide. Make sure knob is loosened and safety pin is pulled to
allow removal of Slide mount Slide.
FIGURE 1
SLIDE MOUNT
END CAP
PLASTIC SLIDE
MOUNT SLIDE
2. Position the Slide Mount Slide onto the top rail of the cargo
management track (See Figure 2). IMPORTANT: Use care in
bending the slide around the formation in the rear of the truck bed.
Over bending could damage the slide.
FIGURE 2
Back Rack/Divider and Overhead Rack
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11 28JN07
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
Quantity
6MM BUTTON HEAD SCREW
REVISION
F
1
1
1
1
Back Rack Divider Shown
1
Overhead Rack will not
4
have Divider tubes
4
2
2
3. Hook and rotate Slide Mount onto top rail of cargo management
track. If the rack is to be positioned at the front of the bed, the
slide mount (A) with the safety pin should be installed on the
Driver side. Otherwise, if the rack is to be positioned at the rear of
the bed, the slide mount (A) with the safety pin should be in-
stalled on the Passenger Side.
FIGURE 3
ROTATE INTO UPRIGHT
4. With Slide Mount in place on top rail, insert Slide back into Slide
Mount. Attach the Slide Mount End Cap with 6mm button head
cap screw. Ensure screws are fully driven, fully seated and not
stripped.
FIGURE 4
IR 28JN07
INSTALLATION INSTRUCTIONS
AUTH DR
TITLE
Back Rack/Divider and Overhead Rack
PART NO.
19169818
6200 Grand Pointe Dr., Grand Blanc, MI 48439
2
1
3
7
POSITION
SAFETY PIN
PART NO. 19169818
SHEET
3
5
4
8
9
PIVOT BLOCK
MOUNTING HOLES
COUNTER SINKS
LOCATED ON
UNDERSIDE OF
SLIDE MOUNT
1 9
SHEET OF
1 9
OF