GM 19170239 Instrucciones De Montaje

Splash Guards - Front
Parts List:
Description
Left Splash Guard
Right Splash Guard
Plastic Push Pin
Alcohol Wipe
Tools Required:
Flat Blade Screwdriver
Time Required:
0.5 Hours Per Pair
Installation Instructions:
1. Turn wheels all the way in one direction to allow work area
clearing.
2. Parts and vehicle temperature must be between 61ºF and
86ºF (16ºC and 31ºC).
3. Remove the 4 existing push pins from the fender lip using a
flat blade screwdriver or putty knife and discard. Figure 1.
FIGURE 1
EXISTING
PUSH PINS
(DISCARD)
4. Clean the outside fender area where guard will touch, using
the supplied alcohol wipe, or 50% alcohol and water.
5. Place the guard against the fender to get familiar with the fit.
Splash Guards
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11 21AP08 I
WHITE 16 POUND NON-BOND
15MY08 R
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
Quantity
1
1
8
1
REVISION AUTH
6. Insert the supplied push pins in the inner holes of the splash
guard and push the center of the pins about half way in to
hold the guard in place. Figure 2.
FIGURE 2
7. Remove the tape backing strip by pulling the tab.
8. Re-check the alignment of the guard to the fender and the
ground and press into position, ironing the tape into place,
starting at the lower end and working up and using 20-30lbs.
of force. Figure 3.
FIGURE 3
TAPE
9. Push all four pin heads into pin body. Figure 4.
FIGURE 4
SUPPLIED
PUSH PINS
10. Repeat the procedure for the opposite side.
PART NO.
REV15MY08
INSTALLATION INSTRUCTIONS
DR
TITLE
Splash Guards
PART NO.
19170239
6200 Grand Pointe Dr., Grand Blanc, MI 48439
TAPE
19170239
SHEET
1
SHEET
1 9
OF
9
OF