Descargar Imprimir esta página

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Cadillac Clear Tail Lamps
Package Contents:
Description
Left Hand Tail Lamp
Right Hand Tail Lamp
Instruction Sheet
Tool Required:
#2 Phillips Screwdriver
Installation Procedure:
1. Open the liftgate to access tail lamp screws.
2. Remove existing tail lamps by removing two Phillips head
screws on the lamp cuff.
3. Pull rearward on lamp to detach outboard retainers from
body (Item 2 – Figure 1).``Some effort is required to disen-
gage the locating retainers and they pull apart from the
lamps and have to be removed from the body.
4. Locate lamp wire harness connection under body (Item 4 -
Figure 1).
5. Disconnect the lamp wire harness connector by pressing
down on the connector release tab and pulling each end of
the connector, separating the two sides.
6. Connect the Clear Lens Lamp wire harness by properly
aligning the connectors and pressing the two mating con-
nectors together. You should hear an audible click.
7. Route wire harness and position lamp near body opening.
8. Install the Clear Lens Lamp into the body by positioning the
lamp and aligning the two outer locating retainers into the
body holes. Press the lamp into position until the locating
retainers are fully seated. Pull slightly rearward on the lamp
to ensure the retainers are fully seated.
9. Align the lamp with the body panels and reinstall the two
Phillips head screws. Torque the screws to 2Nm (18 lb in).
10. Repeat procedure for other side.
11. Once installation is complete, use an outside observer to
verify that all functions of the lamps are operational.
Cadillac Clear Tail Lamps
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
13JL07 Initial Release - Anthony Koulchar
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
Quantity
1
1
1
REVISION
AUTH
FIGURE 1
PART NO.
IR 13JL07
INSTALLATION INSTRUCTIONS
DR
TITLE
Cadillac Clear Tail Lamps
PART NO.
19171265
6200 Grand Pointe Dr., Grand Blanc, MI 48439
2
3
5
4
19171265
SHEET
1
SHEET
1
1
3
OF
3
OF

Publicidad

loading

Resumen de contenidos para GM 19171265

  • Página 1 Phillips head screws. Torque the screws to 2Nm (18 lb in). 10. Repeat procedure for other side. 11. Once installation is complete, use an outside observer to verify that all functions of the lamps are operational. PART NO. 19171265 Cadillac Clear Tail Lamps IR 13JL07 SHEET ALL INFORMATION WITHIN...
  • Página 2 10. Reprendre la procédure sur l’autre côté. 11. Une fois l’installation achevée, demander à une autre personne de confirmer que toutes les fonctions des feux sont en règle. PART NO. 19171265 Cadillac Clear Tail Lamps IR 13JL07 SHEET ALL INFORMATION WITHIN...
  • Página 3 10. Repita el procedimiento para el otro lado. 11. Una vez esté completa la instalación, utilice un observador externo para verificar que operen todas las funciones de las luces. PART NO. 19171265 Cadillac Clear Tail Lamps IR 13JL07 SHEET ALL INFORMATION WITHIN...