Descargar Imprimir esta página

GM 19172892 Instrucciones De Montaje

Gmc yukon 2009-2011; chevrolet tahoe 2009-2011; cadillac escalade 2009-2011

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Roof Rack Cross Rails
Contents
Front Crossrail (Longer)
Rear Crossrail (Shorter)
Instruction Sheet
Screw
Slider Block Assembly (Right Hand)
Slider Block Assembly (Left Hand)
Plugs
Access Cover (Right Hand)
Access Cover (Left Hand)
Wrench - T-25
Tools Required
M6 Torx Head Screw Driver
NOTE: For sunroof vehicles: The front cross rail should be placed
half way between the front and rear sunroofs.
For non-sunroof vehicles: The front cross rail should be placed at the
rear of the front door.
On all vehicles, the rear cross rail should be placed at the rear of the
vehicle. This is the optimum placement of the cross rails for wind
noise reduction.
NOTE: When the crossrails are not in use, place the crossrails at the
following position for wind noise reduction. The front and rear crossrail
should be stowed at a minimum of 14 inches apart.
NOTE: Loading cargo on the luggage carrier that weighs more than
200 lbs (91 kg) or hangs over the rear or sides of the vehicle may
damage your vehicle. Load cargo so that it rests on the cross rails as
far forward as possible and against the side rails, making sure to
fasten it securely.
Installation Procedure
1. Insert slider blocks into center of rail channel and slide into
desired position.
2. Install cross rail assembly to slider blocks as shown.
Roof Rack Cross Rails
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
10AP08 Initial Release - Samecika Williams
WHITE 16 POUND NON-BOND
05DE08 Revised - Samecika Williams
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
20FE09 Revised - Samecika Williams
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
Quantity
1
1
1
8
2
2
2
2
2
1
REVISION
AUTH
3. Move cross rail to desired position along side rail and secure to
slider blocks using 2 screws and Torx head screw driver.
4. Place covers on cross rail supports and install torx head screws.
5. Repeat for rear cross rail.
6. Install rail plugs.
PART NO.
REV 20FE09
INSTALLATION INSTRUCTIONS
DR
TITLE
Roof Rack Cross Rails
19172892
PART NO.
6200 Grand Pointe Dr., Grand Blanc, MI 48439
FORWARD
19172892
SHEET
1
SHEET
1
3
OF
3
OF

Publicidad

loading

Resumen de contenidos para GM 19172892

  • Página 1 1. Insert slider blocks into center of rail channel and slide into desired position. 5. Repeat for rear cross rail. 6. Install rail plugs. 2. Install cross rail assembly to slider blocks as shown. 19172892 PART NO. REV 20FE09 Roof Rack Cross Rails SHEET...
  • Página 2 à la position voulue. 5. Reprendre cette procédure pour la traverse arrière. 6. Installer les obturateurs. 2. Installer l’ensemble de traverses sur les coulisseaux, tel qu’illustré. 19172892 PART NO. REV 20FE09 Roof Rack Cross Rails SHEET...
  • Página 3 5. Repita para el riel transversal trasero. 6. Instale los tapones del riel. 2. Instale el ensamble del riel transversal en los bloques del deslizador como se muestra. 19172892 PART NO. REV 20FE09 Roof Rack Cross Rails SHEET...