Assembling The Basic Trainer - Tacx T1670 Manual Del Usuario

1 ASSEMBLING BASIC
The ergotrainer Basic consists of the collapsible frame on which you mount your bike
(the CycleForce trainer is standard suitable for racing and hybrid bikes and mountain bikes
with a wheel diameter of 630 - 690 mm) and the Basic computer.
Assembling the Trainer
The following steps show how to assemble and adjust the trainer.
1 Press nut A into cap B and slide the cap into the frame tube (fig. 1).
2 Assemble base C to the frame using bolt D. Tighten bolt D but make sure
the base is still adjustable.
3 Unfold the trainer and place it on a level surface. By fully squeezing grip E,
the trainer can be folded out or collapsed (fig. 1).
4 Turn base C to the correct position (fig. 2). Tighten bolt D firmly and attach
anti-slip rubber F (fig. 4).
5 Assemble 2 rubber rings G and part K to handle H (fig. 3). Than assemble the complete
handle to the frame, shove unit I into part K of the handle and turn bolt J until the mag unit
is firmly tightened but it should still be able to move (fig. 4).
6 Replace the quick-release skewer on the rear wheel with the skewer X supplied by Tacx.
This assures ideal clamp fitting and stability. Place the bike in the trainer and adjust the wing
bolt L of the trainer, so that the speed tension clamp M will close without forcing. Forcing
could cause damage!
7 Fix wing bolt L by tightening wing nut N.
-
1
2
B
M
A
C
D
4
C
GB
N
X
I
E
F
3
Assembling Basic
10 mm
13 mm (2x) 13 mm (2x)
L
J
K
H
K
G
H
41