Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 46
CD/MD playback
Problem
A disc cannot be loaded.
Playback does not begin.
CD/MD will not be ejected.
The operation buttons do not
function.
The sound skips due to
vibration.
The sound skips.
Cannot turn off the "--------"
indication.

Radio reception

Problem
Preset tuning is not possible.
Automatic tuning is not
possible.
The stations cannot be
received.
The sound is hampered by
noises.
The "ST" indication flashes.
42
Cause/Solution
•Another MD is already loaded.
•The MD is forcibly inserted upside down or in the wrong
way.
Defective MD or dirty CD.
You have closed the front panel or pushed the disc forcibly
into the unit while the unit was ejecting the disc after you
pressed (Z).
t Press the reset button to initialize the unit.
Press the reset button.
•CDX-C8000RX/CDX-C8000R:
The unit is installed at an angle of more than 60°.
MDX-C8500R:
The unit is installed at an angle of more than 20°.
•The unit is not installed in a sturdy part of the car.
A dirty or defective disc.
You cannot label CDs unless you connect a CD unit with the
custom file function.
t Press (LIST) for two seconds.
Cause/Solution
• Memorise the correct frequency.
• The broadcast signal is too weak.
The broadcast signal is too weak.
t Use manual tuning.
Connect an power aerial control lead (blue) or accessory power
supply lead (red) to the power supply lead of a car's aerial
booster.
(When your car has built-in FM/MW/LW aerial in the rear/
side glass only.)
•Tune in the frequency accurately.
•The broadcast signal is too weak.
t Set to Mono mode (page 19).

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cdx-c8000rMdx-c8500r

Tabla de contenido