Legal Notices - Canon imageRUNNER ADVANCE C2030i Manual De Instrucciones

Legal Notices

Product Name
Safety regulations require the product's name to be registered. In some regions where this product is sold, the following name(s) in
parenthesis may be registered instead.
• imageRUNNER ADVANCE C2030i/C2030L (F155800)
• imageRUNNER ADVANCE C2025i (F155800)
• imageRUNNER ADVANCE C2020i/C2020L (F155800)
EMC requirements of EC Directive
This equipment conforms with the essential EMC requirements of EC Directive. We declare that this product conforms with the EMC
requirements of EC Directive at nominal mains input 230 V, 50 Hz although the rated input of the product is 220 to 240 V, 50/60 Hz. Use of
shielded cable is necessary to comply with the technical EMC requirements of EC Directive.
Laser Safety
This Product is certified as a Class I laser product under IEC60825-1:2007 and EN60825-1:2007. This means that the product does not
produce hazardous laser radiation.
Since radiation emitted inside the product is completely confined within protective housings and external covers, the laser beam cannot
escape from the machine during any phase of user operation.
Do not remove protective housings or external covers, except as directed by the equipment's manual.
Additional Information
When servicing or adjusting the optical system of the product, be careful not to place screwdrivers or other shiny objects in the path of the
laser beam. Also, accessories such as watches and rings should be removed before working on the product.
The reflected beam, even though visible or invisible, can permanently damage your eyes.
The label shown below is attached to the paper drawer's right cover and toner supply port cover.
This Product has been classified under IEC60825-1:2007 and EN60825-1:2007, which conform to the following classes;
CLASS 1 LASER PRODUCT
LASER KLASSE 1
APPAREIL A LASER DE CLASSE 1
APPARECCHIO LASER DI CLASSE 1
PRODUCTO LASER DE CLASE 1
APARELHO A LASER DE CLASSE 1
LUOKAN 1 LASER-TUOTE
LASERPRODUKT KLASS 1
Use of controls, adjustments, or performance of procedures other than those specified in the manuals for this
machine may result in hazardous radiation exposure.