Getting Started; Resetting The Unit; Detaching The Front Panel - Sony CDX-C6600 Manual De Instrucciones

Ocultar thumbs Ver también para CDX-C6600:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Getting Started

Resetting the unit

Before operating the unit for the first time or
after replacing the car battery, you must reset
the unit.
Remove the front panel and press the reset
button with a pointed object, such as a
ballpoint pen.
Reset button
Notes
• Pressing the reset button will erase the clock and
some memorized functions.
• When you connect the power supply cord to the
unit or reset the unit, wait for about 10 seconds
before you insert a disc. If you insert a disc within
these 10 seconds, the unit will not be reset, and
you will have to press the reset button again.

Detaching the front panel

You can detach the front panel of this unit to
protect the unit from being stolen.
1
Press (OFF).
2
Press (RELEASE) to then slide the front
panel a little to the left, and pull it
towards you.
(OFF)
(RELEASE)
Notes
• Be sure not to drop the panel when detaching it
from the unit.
• If you detach the panel while the unit is still on,
the unit will turn off automatically to prevent
the speakers from being damaged.
• When you carry the front panel with you, use the
supplied front panel case.
Attaching the front panel
Align part a of the front panel to part b of
the unit as illustrated, and push until it clicks.
b
Notes
• Be sure not to attach the front panel upside
down.
• Do not press the front panel too hard against the
unit when attaching it.
• Do not press too hard or put excessive pressure
on the display window of the front panel.
• Do not expose the front panel to direct sunlight,
heat sources such as hot air ducts, and do not
leave it in a humid place. Never leave it on the
dashboard of a car parked in direct sunlight or
where there may be a considerable rise in
temperature.
Caution alarm
If you turn the ignition key switch to the OFF
position without removing the front panel, the
caution alarm will beep for a few seconds.
If you connect an optional power amplifier and
do not use the built-in amplifier, the beep
sound will be deactivated.
a
5

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido