Connecting To The Mains; Safety Instructions - UFESA CE7141 Instrucciones De Uso

ENGLISH
1. Main body
2. Water tank with lid
3. Water/Steam nozzle
4. Detachable drip tray cover
5. Drip tray
6. Coffee spoon
7. 1 cup filter
7a. 2 cup filter
8. Filter holder
9. ON/OFF button
10. Espresso/Steam button
11. Pump control button
12. Steam regulator
13. Cup warmer
14. ON/OFF lamp
15. "Temperature reached" lamp

CONNECTING TO THE MAINS:

Before plugging the appliance into the mains, make
sure that the voltage corresponds to that stated on
the characteristics plate. Plug the appliance into an
earthed socket.

SAFETY INSTRUCTIONS:

• Read these instructions carefully. Safeguard them for
future reference.
• Do not touch any hot surfaces. Handle the coffee
maker by the handles or by means of the switches.
• Do not switch the coffee maker on without any water.
• Keep an eye on the coffee maker while it is working,
especially when there are children about.
• Never use the coffee maker without the drip tray and
drip tray cover.
• Never immerse the appliance in water or any other liquid.
• Unplug the coffee maker from the mains before
proceeding to clean it or if it is not operating correctly.
• Leave the hot parts to cool down before proceeding
to clean them.
• Never leave the cable hanging freely. Keep the coffee
maker and the cable away from any heat sources.
• This appliance has been designed exclusively for
domestic use.
• Do not use the coffee maker if either the cable or plug
are damaged, or if it is not operating correctly or has
become damaged.
• Do not leave the appliance in temperatures below
zero, as the water contained inside may damage it.
• Cable repairs and replacements must be carried out
exclusively by an Authorized Technical Service Centre.
• This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
• Children should be supervised to ensure that they do
not play with the appliance.
BEFORE ITS FIRST USE:
Before using the coffee maker for the first time, wash
all of its accessories in soapy water and dry them.
Use the appliance as if it were about to make an
espresso coffee but without any coffee, so as to flush
through all of the internal parts of the coffee maker.
CE7141 manual.indd 6 CE7141 manual.indd 6
NOTE: There may be noise and no water comes out
when pump the water at the first time, it is normal, you
should turn the steam regulator to the opening position
to release the air in the appliance. After about 20s, the
noise will disappear and the water will come out.
PREPARING ESPRESSO WITH COFFEE
POWDER
1. Fill the water tank with cold water and place it into
the suitable position (Fig. 1).
2. Press the ON/OFF button (9) to start the machine.
Lamp 14 will light up. Make sure the coffee/steam button
is on the higher position which is the
down the pump control button (11) to the lower position
which is the " " position, when there is water flowing
out, close the pump IMMEDIATELY by pressing the
pump control button (11) again to the higher position of
" ". The purpose of the step is that pump the water of
the tank into the housing.
3. This coffee maker is equipped with special coffee
filters which ensure that the coffee comes out creamy.
Owing to the way it works, a small amount of water will
be left over in the filters.
Fit the suitable coffee filter into the filter holder (8). Use
the small 1 cup filter for one cup of espresso (Fig. 2a)
or the large 2 cup filter for two cups of espresso
(Fig. 2b). Fill the filter using the measuring spoon
(1 spoonful per 1 cup).
Clean away any coffee that may remain around the
edge of the filter holder. The coffee powder could not
exceed the max level in the filter after being pressed.
4. Place the filter holder into its housing (Fig. 3). Turn
the filter holder round to the right until you notice it to
stop. Do not force it.
5. When lamp 15 turns green, coffee maker have
reached the right temperature. Press down the pump
control button to the lower position which is the "
position, after a moment, hot coffee is flowing out. To
stop the flow of coffee, press the button again as in .
ATTENTION: Do not try to release the filter holder (8)
while button (11) is on (Fig. 7). For your safety, wait until
the coffee maker has cooled down before releasing the
filter holder once the machine has been turned off.
Given that the coffee maker is fitted with a self-priming
system there is no special procedure to carry out when
the tank runs out of water or after a prolonged period
where the coffee maker has not been used.
PREPARING ESPRESSO WITH COFFEE PODS
Apart from ground coffee this coffee maker can also
use single portions of coffee. There are two types of
coffee pod available in the market:
A - 60mm flexible (loose) coffee pods, suitable for
drip-fed coffee makers and percolators
B - 44mm packed coffee pods, especially for espresso
machines
Your coffee maker will not operate correctly with 60mm
flexible coffee pods as they do not fit properly in the
filter holder.
Always use packed coffee pods of approximately
44mm diameter with this coffee maker, see Fig. 2d.
These single coffee pods can be found at your usual
retailers.
1. Fit the pod filter into the filter holder. Put 1 coffee pod
into the small 1 cup filter. (Fig. 2c)
2. Then follow steps 3-4 of the instructions for making
espresso with coffee powder.
position. Press
"
2009-06-17 5:14:45.MD 2009-06-17 5:14:45.MD