Chamberlain C2202 Manual De Instalación página 28

Ocultar thumbs Ver también para C2202:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
STEP 14 Wire the Safety Reversing Sensors
If your garage has pre-installed wiring for the safety reversing sensors, see OPTION B - PRE-WIRED
INSTALLATION page 29.
OPTION A - INSTALLATION WITH NO PRE-WIRING
1.
Run the wire from both sensors to the garage door opener. Attach with staples, but DO NOT puncture
the wire.
2.
Separate the sensor wires and strip insulation from each end. Twist the two white wires together. Then
twist the two white/black wires together.
3.
Using a screwdriver, push in the terminal tabs, and insert the white wires into the white terminal.
Insert the white/black wires into the grey terminal.
Insulated Staple (Not Shown)
1
Staple
3
28
HARDWARE
2
7/16" (11 mm)

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido