Installation; Installing The Condensate Pump; Connecting The Condensate Pump - Bosch CP1 Instrucciones De Instalación

Installation

3 Installation
3.1

Installing the condensate pump

When installing the condensate pump, observe the following:
• Use suitable means to ensure moisture protection.
• Fit the condensate pump horizontally near the appliance.
• Position the condensate pump in easy access for maintenance and
inspection.
• Use suitable rawl plugs for the base on which the condensate pump is
fitted.
Use different rawl plugs from those provided if required.
• Test the load bearing capacity of the substrate.
• Observe the maximum delivery head of 4.5 m (
• Ensure the hose is routed correctly with a fall of 1 % (
B Position the condensate pump against the wall and level with a spirit
level.
B Mark the positions of the rawl plugs on the wall.
Fig. 5 Levelling the condensate pump
B Drill holes for the rawl plugs.
B Insert rawl plugs into the holes.
B Insert the screw halfway into the rawl plug.
B Remove fuse [1].
Fig. 6 Removing the fuse
[1] Fuse
B Hook the condensate pump onto the screws.
B Tighten the screws.
3.2

Connecting the condensate pump

NOTICE: Damage to the condensate pump due to
incorrect use.
B Never step on the casing.
B To prevent the thread from stripping, never place any
stresses on the hoses.
12
Fig. 3 and Fig. 10).
Fig. 10).
6 720 645 612-07.2ITL
1
6 720 645 612-12.1ITL
NOTICE: System damage due to corrosion
B Use plastic or stainless steel for on-site lines and
connection pieces that carry condensate (e.g. from
the flue to the boiler or neutralising system).
B Fit supply hose [2] to the condensate drain in the appliance that
expels condensate.
B Fit supply hose [2] to condensate inlet connection [1] on condensate
pump [3].
2
1
Fig. 7 Fitting the supply hose
[1] Condensate inlet connection
[2] Supply hose Ø 28 mm (not part of standard delivery)
[3] Condensate pump
NOTICE: System damage
B Use the hose provided as part of the standard delivery
for the condensate drain.
B Fit drain hose [3] to condensate drain [1] on condensate pump.
B Use an adapter if the hoses have different diameters (
B Fit locking device [4] and secure hose using hose clip [2].
3
2
1
1.
Fig. 8 Fitting the drain hose
[1] Condensate drain
[2] Hose clip
[3] Ø 10 mm drain hose
[4] Locking device
3
6 720 645 612-11.2ITL
Fig. 9).
3.
2.
6 720 645 612-13.1ITL
CP1 – 6 720 645 612 (2012/10)
4