Using Orbea Rs Toolbox - Orbea BLUE PAPER URRUN 2022 Manual Tecnico

38 | ORBEA
4. Scroll through the data to be seen on the screen. Se-
lect Connect IQ and choose Orbea RS Toolbox.
If you had not connected your Urrun before setting up
Toolbox on your device, the unit will show the message
"Searching..." after selecting the Orbea RS Toolbox
the page where you chose to see Toolbox, the data
from your Urrun will be visible.
If after selecting Orbea RS Toolbox the screen
shows the message "Unlock in Connect IQ",
the downloaded version has not been cor-
rectly unlocked. Connect your device to your
computer and restart again the Unlocking
and Downloading procedure through Garmin
express as described in the previous section.
5.
which you selected to see the data from Toolbox or start
unit. Navigate to the page you selected to see Toolbox
on to access the real-time data from your Urrun.
TECHNICAL MANUAL
Garmin Edge units
Garmin watches
Garmin Edge units
Garmin watches
B LUE PAP ER U RRU N · 2022
USING ORBEA TOOLBOX
Orbea RS Toolbox is not compatible
with the use of the Garmin Edge Shima-
no STEPS native app on Edge 530, 830,
1030, and 1030 Plus devices. Disconnect
or delete your bicycle from the sensors list
of your Edge unit before trying to connect
Orbea RS Toolbox. This limitation does not
come from Toolbox, but from Garmin.
CONNECT YOUR URRUN TO ORBEA RS TOOLBOX
Always turn your Garmin on and start recording an activity
and then turn your bicycle on for the remaining battery
Otherwise, the remaining battery level will be displayed
when some distance has been covered and the battery
level drops by 1%.
When starting Toolbox, it will connect to the bike with the
strongest signal (normally the closest one) and, once con-
nected, it will stay paired to that bike. If you are experi-
encing pairing problems, make sure your Urrun is the only
bicycle turned on to make the connection easier.
ORBEA | 39
Urrun and Toolbox will connect via ANT Private automati-
cally. If the data from your Urrun is not shown in Toolbox,
try to change assist levels with the handlebar remote. If
the Toolbox data is still not visible, switch Urrun off and
turn it back on to reset the connection.
AVAILABLE INFORMATION IN ORBEA RS TOOLBOX
ASSIST MODE: Shows the currently selected assist mode
from the modes available: Off, Eco, Trail, Boost.
· Assist mode visualization options (on Garmin watch-
es): Orbea RS Toolbox allows you to see the currently se-
lected assist mode in two different ways. Read the Data
Fields Customization section of this manual to learn
. You can choose to see the selected assist mode on
the name of the selected mode.
. It is also possible to see the selected assist modes
on the external colour band around the screen. When
selecting an assist mode, the corresponding area will
be highlighted. The assist modes colour codes are :
E N