Descargar Imprimir esta página

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Convenience Net Assembly
Convenience Net:
A convenience net anchored between the second row Captain
Seats helps keeps small items in place during sharp turns or
quick stops and starts. The net is not designed to retain these
items during off road use. The net is not for larger, heavier
items. Please note to detach the net assembly prior to the fold
and tumble operation of the seat.
Installation Instructions
90mm
1. With seat in upright position, measure and mark the right-
side plastic seat panel of the drivers-side 2nd row seat in
the following locations for drilling. Repeat for step for pas-
sengers side 2nd row seat left-side plastic seat panel.
Convenient Net Assembly
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
17OC05 I
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
235mm
83mm
162mm
REVISION
2. With seat in upright position, and using a 1/8" drill bit with a
1/4" drill stop, carefully drill the marked areas on the seat's
plastic side panels. Be sure to not pass through the seat's
plastic side panels more than 1/4" in depth. Then enlarge
the pilot holes using a 5/16" drill bit with a 1/4" drill stop.
Vacuum plastic drill shavings when finished.
3. With seat in upright position, insert the T-Anchor/Well Nut
assemblies into the drilled holes, ensure that the plastic
spacer is placed on the hardware assembly. Turn the T-
Anchor/Well nut assembies clockwise until hand tight.
Orientate T-Anchor in the up-down position as shown. Once
all T-Anchor/Well nut assemblies are tightened, attach the
cargo net loops to the anchors as shown.
4. With seat in upright position, this is what your finished
installed net assembly should look like. Please note to
detach the net assembly during fold and tumble operation of
the seat.
IR 17OC05
PART NO.
INSTALLATION INSTRUCTIONS
AUTH
DR
TITLE
Convenience Net Assembly
PART NO.
19132225
6200 Grand Pointe Dr., Grand Blanc, MI 48439
19132225
SHEET
1
SHEET
1
3
OF
3
OF

Publicidad

loading

Resumen de contenidos para GM 19132225

  • Página 1 4. With seat in upright position, this is what your finished installed net assembly should look like. Please note to detach the net assembly during fold and tumble operation of the seat. 19132225 Convenient Net Assembly IR 17OC05 PART NO.
  • Página 2 4. L’installation achevée du filet d’arrimage devrait ressembler à ceci tandis que le siège est en position verticale. Prière de détacher le filet d’arrimage pour replier le siège. 19132225 Convenient Net Assembly IR 17OC05 PART NO.
  • Página 3 4. Con el asiento en posición vertical, la instalación terminada del ensamble de red debe verse así. Tenga cuidado de desenganchar el ensamble de red antes de doblar y voltear el asiento. 19132225 Convenient Net Assembly IR 17OC05 PART NO.