Publicidad
10
10
NAIL
(52 used in this step)
Carefully turn your unit over onto its front edges. Unfold the BACK (K) and lay it over the center of your unit.
Make equal margins along all four edges of the BACK (K). Push on opposite corners of your unit if needed to make it "square".
Fasten the top and bottom edges of the BACK (K) to your unit using the NAILS (FF).
Next, fasten the SMALL BACKS (J) to your unit using the NAILS. The SMALL BACKS will overlap the BACK (K).
NOTE: Perforations have been provided for access through the BACKS. Carefully cut out the holes needed.
Page 14
J
K
FF
www.sauder.com/services
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
J
413043
Publicidad
