Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
We compliment you on your purchase and thank you for your confidence in us. You are advised to carefully read
these directions, which will enable you to use the Vacuum Packing System properly and obtain optimal results in terms
of food preservation. Furthermore, we suggest you keep these instructions handy for further reference.
SECTION 1
SEE ILLUSTRATIONS
(1) ON/SEAL indicator light - While the appliance is in the
vacuum-forming phase the light will be steadily lit; it will
then flash during the final sealing phase. When it goes off
you can open the machine.
(2) Lid - Opening the lid into the fixed raised position allows
you to position the bags before starting the vacuum
packing process.
(3) Lid manual valve - Press it to stop the vacuum packing
cycle at any time or to open the lid at the end of the
cycle.
(4) Hose air inlet - To connect the hose to jars, containers,
universal caps, bottle caps etc.
(5) LOCK buttons - In the locked position they secure the
lid in place while the vacuum packing cycle is under way
in bags, jars and containers; they release automatically.
Carefully read all the instructions before using the appliance,
and keep them handy for future reference.
- Inappropriate use of the appliance will render the Guarantee
null and void.
- Check whether your voltage corresponds to the voltage
printed on the characteristics plate of the appliance.
Any error whatsoever in its connection will render the
Guarantee null and void.
- This appliance was designed for exclusive domestic and
inside the home.
- This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of
the appliance by a person responsible for their safety.
- The appliance is not designed for continuous operation.
Do not carry out more than one complete cycle every 2
minutes.
PATENTED
THE VACUUM PACKING SYSTEM FOR THE HOME
TABLE OF CONTENTS
page
24
page 24-25
page 25-26
page
27
page
27
page 27-28
APPLIENCE NAMES AND FUNCTIONS
SAFETY PRECAUTIONS
24
SECTION 2
-INFORMATION ON VACUUM PRESERVATION OF
FOODSTUFFS
(6) Sealing bar - Protected heating element that seals the
bag and prevents it from sticking to the bar.
See illustrations on page 1.
(7) Airtight gaskets - They guarantee that a vacuum will be
maintained in the chamber, thus allowing air to be removed
from bags and containers.
(8) Sealing gasket - It presses the bag against the sealing bar.
(9) Vacuum chamber - The open end of the bag is positioned
inside the chamber, air is draw from the bag and any
excess liquid is collected on the bottom.
(10) Lower part - Entirely removable and washable also in
dishwasher for maximum hygiene.
(1 1) Non-slip feet - They prevent the appliance from slipping
during use.
- In extreme ambient conditions, an intensive use of the
appliance may trigger the automatic thermal protection
devices.
In such a case allow the appliance to cool down sufficiently
to enable resetting of the protection devices.
- As with any appliance whatsoever, never allow children to
use the appliance unsupervised.
- Place the appliance on a horizontal and stable surface.
- Do not use the appliance on or in proximity to hot surfaces.
- The casing of this unit is not protected again the penetration
of liquids.
- Do not draw liquids into the vacuum chamber. Should this
happen, immediately dry the vacuum chamber.
- Do not immerse the appliance in water and do not use it
if the cord or plug are wet; should they get wet during use,
immediately pull out the plug wearing dry rubber gloves.
- Do not remove or touch the appliance under water until
you have pulled out the plug.
page 28-32
page
28
page
29
page
30
page 30-31
31
page
32
Publicidad
Capítulos
Tabla de contenido
