Publicidad
Idiomas disponibles
Idiomas disponibles
Processing table
Ingredients
Onions (quartered)
Garlic (whole cloves)
Walnuts
Almonds
Cheese (e.g. Gouda, cold)
Salami
Diced lean beef (approx.
2 cm edge length)
Carrots
Dried fruit
Ice cubes
NOTE: The processing times and speeds specified here are guidelines.
• Depending on the quantities and consistency of the foods, the actual values may differ.
• Repeatedly check the results, depending on how small you want to chop the food.
• Work using short pulses (1 pulse: press for approx. 1 second).
Assembling the device
CAUTION: Depending on the hardness and consistency of the food, do not fill the vessel 7 up to the
maximum level, as this can cause the blade insert 6 to become blocked.
Pay attention here to the guideline values for various foods in the "Processing table" section.
1. Place the vessel 7 on the vessel cover 9.
2. Place the blade insert 6 on the spindle 8 in the vessel.
3. Place the prepared food into the vessel7.
4. Figure B: Place the working cover 4 onto the vessel 7 in such a way that the two small tabs on the
working cover fit into the grooves in the vessel and rotate the working cover clockwise until it clicks
into place.
5. Place the motor block 3 into the upper edge of the working cover 4.
NOTE: The motor block does not fit onto the working cover entirely straight on the right-hand side.
6. Insert the mains plug 2 into a wall socket corresponding to the technical data.
Shredding
• Figure C: In order to work at normal speed, press the motor block 3 down and then release it again.
• Figure D: In order to work at high speed, additionally press down on the TURBO 1 button.
• Work using short pulses (1 pulse: press for approx. 1 second). The number and length of the pulses
will depend on the quantity and consistency of the food. See the specifications given in the "Processing
table" section.
• Repeatedly check the result. If the food is not being chopped evenly:
- Pull out the mains plug 2, remove the motor block 3 and thoroughly shake the vessel 7.
- If food is sticking to the inside wall of the vessel, rotate the working cover 4 anti-clockwise and remove
it. Push the pieces downwards using a spatula.
- Put all the pieces back together before you reinsert the mains plug 2 into a wall socket and resume
work.
Cream attachment
Application area
The cream attachment 5 has been specially designed for whipping cream in the multi chopper. It is
placed on top of the blade insert 6.
Recommended quantity
100 g
100 g
50 g
50 g
100 g
130 g
250 g
100 g
130 g
100 g
- 12 -
Recommended processing time / speed
Pulse/TURBO
Pulse/TURBO
2 x 8 sec. TURBO
1 x 10 sec. (coarse) 1 x 30 sec. (fine) TURBO
4 x 15 sec. TURBO
3 x 5 sec. TURBO
3 x 12 sec. TURBO
3 x 5 sec. normal
4 x 15 sec. TURBO
Pulse/TURBO
Publicidad
