Tristar AC-5492 Manual De Instrucciones página 6

POWER SOURCE
The AC socket must be firm and reliable.
Don't connect the mobile air conditioner to a multiple socket outlet which is also being used for other
WARNING
electrical appliance.
Insert the AC power plug securely into the AC socket before using the unit, when it beeps after two
seconds, press" ON/OFF "button, the unit begins to run.
COOLING OPERATION
1.Repeatedly press "MODE" button to choose the cooling mode, LCD window will show "COOL".
CAUTION
During the cooling operation, always place the duct through an open window to exhaust warm air from
the room.
2. Repeatedly press " TEMP+" or "TEMP –" button to set a proper room TEMP. at 17 -31
(63 -88 ).
3. Press "FAN SPEED" button to choose a proper fan speed, high, middle, low speed.
4. Press "SWING" button to adjust air delivery direction, The LCD window will show "
NOTE:
In order to improve the cooling efficiency, be careful that:
a) If your room is directly exposed to the sun, pull down the curtains please.
b) Do not place the machine near other heat source.
DEHUMIDIFYING OPERATION
1. Keep the windows and the doors closed to help dehumidify the room effectively.
2.Repeatedly press " MODE" button to choose the dehumidifying mode, LCD window will show "DRY", the fan
speed cannot be adjusted.
3. When used only as a dehumidifier, do not use the air exhaust duct.
HEATING OPERATION
1. Repeatedly press the "MODE" button, select the heat mode, The LCD window shows "HEAT".
2. Press "TEMP+" or "TEMP-" button to set a proper room temperature at 17 -31 or (63 -88 ).
3. Press "FAN SPEED" button to choose the fan speed: high-middle-low.
4. Press "SWING" button to adjust the air delivery direction, The LCD window will show "
TIME SET FUNCTION
To set time to start the machine with the unit off (but with power on), press " TIMER" button, the LCD window will
show " " press the TIME button, set the time to start as you like. The setting range is 1-12 hours.
To set time to stop the machine when the unit is running, press "TIMER" button, the LCD window will show
" ", press the TIME button set the time to stop the machine as you like. The setting rang is 1-12 hours.
If you have set switch on/off after 12 hours, press this key again, then you could cancel the timing.
AUTO SWING FUNCTION
1. For auto swing function, press " SWING" button, LCD window will show "
automatically.
2. Press once again " SWING" button, the symbol "
Caution:
Pressing " " and " " buttons together for more than two seconds will lock the keys, on LCD window will show "
" . Pressing the two buttons again can unlock the keys, the symbol "
USE OF CONTROL PANEL
" in the LCD window will disappear, the swing stops.
5
".
", and then begin to swing
" will disappear.
or
"