CASUALPLAY LiVi Manual De Instrucciones página 19

• Lastly unfasten the three press studs found under the seat (fig.23), open and pass the
crotch strap buckle through the hole in the upholstery.
• Follow the same steps in reverse to put the upholstery back on again.
Fitting the rain cover (illustration 24)
• The rain cover is fitted onto the pushchair with the hood open.
• Then fasten the two Velcro strips of the rain cover to the sides of the chassis.
• Lastly, fasten the Velcro strip situated on the lower front part of the rain cover.
Fitting/removing the adaptors
NOTE: the adaptors can only be used in combination with one of
the following complements: Sono, Baby 0+ or Nuno/Folk.
WARNING: the adaptors only have one fitting position, do not try
to force them.
• Put the parking brake on the LIVI.
• Place the adaptor on the side of the LIVI chassis, lining the adaptor up with the anchor
point.
• Slide the adaptor (fig.25) until you hear it click confirming that it is correctly installed
(fig.26).
• Repeat the same steps to fit the other adaptor.
• To remove the adaptors, first press the button upwards and then slide it towards the top
part of the chassis (fig.27).
• Do the same with the other adaptor.
Unisystem
This exclusive anchoring system means that the following complements can be
used on the LIVI pushchair: SONO, BABY 0+ or NUNO/FOLK.
NOTE: The SONO, BABY 0+ or NUNO/FOLK complements can
all be fitted with or without the LIVI upholstery. If you don't want
to remove the upholstery, place the backrest of the LIVI seat in its
lowest position.
WARNING: before installing any complement, you should fit the
adaptors onto the LIVI and make sure that they are correctly
fastened.
• Put the parking brake on the LIVI.
• Place the SONO, BABY 0+ or NUNO/FOLK on the pushchair, facing backwards.
17