Tristar 1006.332 Manual De Instrucciones página 38

Ignition System Check

The ignition test is done
closed.

Test both burners in turn
detailed below

Make sure the control
in and turn the control
ignition position  to the
control clicks.

Repeat this operation, each time checking for a spark at the burner. If spark is not evident at the burner, check that the ignition
lead is firmly attached to the control and spark electrode. With sparking established turn the Control Knob to the OFF position.
Note: If the igniter is faulty the burners can be lit using a lighted match attached to the match holder.
Burner Operation

Open the lid before attempting to light the burners.

The User should always operate the grill with the Drip Tray in place.

Make sure both the control knobs are in the Off  position.

Open the gas cylinder valve.
 To light the burners Push and in and turn the appropriate control knob anti-clockwise through the ignition position  to the High
position , at the same time check that the burner has lit. See note below. The left hand control knob controls the left hand
side burner and the right hand side control knob controls the right hand burner

Once the burner has lit turning the control knob the low position can reduce the temperature of the grill

To turn the burner off, turn the control knob fully clockwise to the off position .

Turn off the gas cylinder valve when the grill is not in use.
Notes:
1.Upon first assembly, the gas line and burners will be full of air. In order for the burners to light properly the lines must fill with gas. It may
require several attempts at lighting the burners before you are successful. If a burner fails to light after several attempts turn off gas
supply at cylinder and read "If the Barbecue Fails to Operate Properly" section below.
2. Note if an igniter is faulty the burner can be lit using a lighted match attached to the match holder.
If the Barbecue Fails to Operate Properly
o
Turn off the gas at the cylinder valve and turn both control Knobs to the OFF position.

Wait 5 minutes before trying to light again.

Check gas supply connections.

Repeat the lighting procedure and if barbecue still fails to operate properly, turn off the gas at the cylinder valve and turn both
control Knobs to the OFF position and wait for grill to cool and check the following:
d) Misalignment of burner tube over orifice
Figure 16
with the gas cylinder valve
by following the procedure
knob is in the off position. Push
knob anti-clockwise through the
High position until the
.
38