Tristar 1006.332 Manual De Instrucciones página 40

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 51
If fire occurs in and around the burner, immediately turn off gas at the cylinder valve and turn the control knobs to the OFF position, wait
until the grill has cooled, then clean the burner tubes and burner ports as described below.
Cleaning the Burner Tubes
In order to clean the inside of the burner tubes, the Burner Assembly must be removed from the grill. Make sure the gas cylinder, Grill
Plates, Drip Tray and Leg Shelf have been removed before proceeding.
Make sure the Grill Control Knobs are turned to the "OFF" position, and the grill has completely cooled.
Disconnect the LP cylinder.
Pull the Control Knobs off the valve stems. Remove the Control Panel and screws securing it.
Remove Spring Clips with screwdriver. (Fig.18)
Remove the electrode Spring Clip by holding end of clip with pliers and pushing down away from the notch in burner bracket. (Fig.19)
Hold spring with fingers so clip dose not flip away.
Turn the grill upside down. Remove the screws holding the Burner Brackets from the bottom side. (Fig.20)
Remove both Burner Assemblies from the grill.
Use a pipe cleaner to clear obstructions from the Burner holes and inlet hole. (Fig.21) Verify that there are no insects or insect nests
blocking the inlet hole. Normal wear and corrosion may enlarge some holes, however, if large cracks or holes are found the Burners
should be replaced.
After cleaning, re-assemble Burner Assemblies and other parts in reverse order of previous Steps 2-9 disassembly. Note: When
refitting the Burners, be sure to check they are positioned correctly with the valves.
Check burner operation after reassembly or cleaning.
Clean the outside of the Burner Assembly with a paper towel or damp sponge. Open any clogged holes with a thin wire.
FIG.20
Cleaning the Grill Plates
After cooking, turn both burner controls to the OFF position and let the grill cool before attempting to clean the grill plates. Before first use
and periodically, it is suggested that the grill plates are washed using warm mild soapy water and a cleaning cloth
FIG.18
FIG.21
FIG.19
40

Publicidad

Tabla de contenido
loading

Tabla de contenido