Pioneer CP-LX70 Manual De Instrucciones página 3

The pillars and speaker stand bases are designed with specific
directional orientation for assembly. During assembly, make sure
they are attached in the correct directions.
Front side
Installing the speaker stands
• Place the stand on a stable, level surface; placing the stand on
an unstable surface can be dangerous.
When placing the speaker, keep in mind that the tone is affected by
the position of the speaker.
If the bass is insufficient, move the speaker closer to the wall. The
richest bass sound is obtained when the speaker is right against
the wall. If the bass is too powerful, producing a muffled tone, move
the speaker away from the wall. Placing the speaker against a thick
curtain may also be effective.
Adjust the position as necessary to obtain optimal sound from your
system.
Rear side
Assembling the speaker stands
Make sure you assemble the stand on a flat surface that is relatively
soft (such as a carpet).
A medium-sized Phillips screwdriver is required for assembly.
• The Styrofoam cushions are used during assembly.
CP-LX70 only: Confirm that the surfaces with printing are
facing upwards and oriented as shown, then align the top
cushion on the bottom cushion as illustrated.
Cushioning
material (Top)
1 Run the speaker cable through the pillar and place the pillar
onto the stand base.
Place the pillar on a flat surface and cut the string that is strung
through the pillar. Tie the speaker cable coming out of the stand
base to the end string at the bottom of the pillar. Pull the end of the
string emerging from the top front side of the pillar to pull the
speaker cable up through the pillar.
• Remove the string once the speaker cable is through the pillar.
Next, stand the pillar upright and fit the bottom of the pillar into the
stand base, making sure that the pillar is aligned with the hole in
the stand base.
• When fitting the pillar into the stand base, make sure that the
speaker cable comes through the groove on the bottom of the
pillar and does not get pinched between the pillar and the stand
base.
• Make sure not to scratch the surface of the stand base with the
pillar, as the decorative laminate of the stand base may scar
easily.
Cushioning
material (Bottom)
3
En