Pioneer CP-LX70 Manual De Instrucciones página 6

Connect the speaker cable to the amplifier
Connect the speaker cable to the terminals located on the rear side
of the stand base.
1 Switch off the power to your amplifier.
2 Connect the speaker cables to the input terminals on the rear
side of the stand base. For input terminal polarity, red is positive
(+) and black is negative (–).
3 Connect the other ends of the cables to the amp's speaker
output terminals (for more details, refer to your amp owner's
manual).
• Grasp the cap knobs on the lower input terminals and rotate
them to the left (counter-clockwise), insert the speaker cable
wires into the holes in the terminal posts, then tighten the
knobs to secure the wires.
• You can also connect the stand base's terminals with a banana
plug. When using a banana plug, be sure to remove the cap at
the tip of the input terminal.
• If the cables' wires happen to be pushed out of the terminals,
allowing the wires to come into contact with each other, it
places an excessive additional load on the amp. This may cause
the amp to stop functioning, and may even damage the amp.
• After connecting the plugs, pull lightly on the cables to make
sure that the ends of the cables are securely connected to the
terminals. Poor connections can create noise and interruptions
in the sound.
• When using a set of speakers connected to an amplifier, you
won't be able to obtain the normal stereo effect if the polarity
(+ , –) of one of the speakers (left or right) is reversed.
6
En
Placement
Finish the installation of the speaker systems in your room by
standing them and their attached stands upright. Refer to the
section "When Installing the Speaker Stands" on page 3.
• The bottom and top cushioning materials should not be
discarded after assembly, but stored in a safe place.
Changing the Speaker Height
When changing the height of the speakers, reassemble the stand
while referring to step 3 through 6 of "Assembling the Speaker
Stand."
• Do not attempt to adjust the speaker height while the stand is
upright. This could cause the speaker to fall, resulting in
damage or personal injury.