Publicidad
Quick start installation and setup
1 Initial condition of the wardrobe
Do not plug the control unit to electricity before connecting all the engines.
Connect all the electric motors of the transmission bars to the control unit according to the wardrobe configuration.
After connecting all the electric motors to the control unit close manually all the doors.
2 Control unit power supply
00:00:10
3 Self-learning cycle
After connecting to the power supply, wait at least 10 seconds, to allow to the control unit to check
the wardrobe configuration.
00:00:03
After connecting all the electric motors to the control
unit and after closing manually all the doors is pos-
sible to connect the control unit to the power supply.
Start the self-learning cycle to make the automatic set-
up of the run of the doors pressing at least 3 seconds
the "SET / RESET" button on the power unit. All the
doors, one by one, starting from the first left door on
the wardrobe, will move at reduced speed until their
final stoppers.
This operation, until all the doors record their run,
may take some minutes.
During the self-learning cycle do not stop or put
obstacles towards the doors and keep the do-
or's run free.
If the position of the final stoppers is modified,
please repeat the self-learning cycle again.
Publicidad
