Adc / 10 Aac+Dc Position; Peak Key; Mem / Auto Mem Key; Key - Metrix MX 26 Manual De Instrucciones

Chapter II
4.1.3. 10 A / 10 A
DC AC+DC
4.2.

+/- Peak key

The fast positive or negative peak measurement functions (> 1 msec.) can be accessed by
repeatedly pressing this key in the V
This key also desactivates the auto power-off, if it is pressed when switching on ("P-OFF"
is displayed).
Automatic shutdown of the instrument is disabled in order to avoid interrupting the peak
measurements (Pk +/-).
4.3.

MEM / AUTO MEM key

Short press (MEM) : Fixes the display on the current value. A second short press returns the
multimeter to normal mode. The "MEM" sign appears on the display.
The MEM mode is available on all measurements.
Long press (AUTO MEM) : Accesses or quits the "autostore" mode.
The "MEM" sign blinking on the display.
Affected ranges : V
Autostore
Set the probes on the point to be measured. An audio signal indicates whether the
measurement is stable. When you remove the probes, a second audible signal indicates
that this stable value displayed has been stored.
The bargraph remains active during the "autostore" and display "MEM "mode.
Pressing this key when switching on the instrument enables the selection of a rejection of
50 or 60 Hz. The selection is reversed from the last configuration. It is displayed for 2
secs. and remains backed up in non-volatile memory.
4.4.

key

Activates/desactivates back lighting of the display unit. It automatically goes off after
≈ 60 seconds.
5000-count portable digital multimeter, with current inputs
Position
10 A
DC
DC current measurement
(Range 10 A )
DC
AC+DC key
10 A
AC+DC
AC+DC current measurement (TRMS)
(Range 10 A )
AC+DC
AC+DC key
, ADP , mA
DC DC DC
, V
LOW Z AC+DC
The AC+DC sign
appears on the display.
and 10 A functions.
DC
, V , ADP , ADP
DC DC AC+DC
23