Sauder 425811 Instrucciones De Montaje página 26

Step 20
Before fastening the DOOR to your unit, be sure the mounting screw is against the stops as shown in the right diagram. If
å
it isn't, loosen the mounting screw to slide it against the stops. Then tighten the mounting screw.
Fasten the DOOR (N) to the LEFT END (B) as shown in the lower diagram. Use the screws in the HINGES. You should start
å
each SCREW a few turns before completely tightening any of them.
Fasten a PULL (149K) to the DOOR (N). Use two SILVER 5/8" MACHINE SCREWS (15S).
å
Repeat this step for the other DOOR (N).
å
See the next step for DOOR adjustments.
å
Fasten the LOCK BRACKETS (9J) to FIXED SHELF (E). Use two
å
SILVER 1/2" FLAT HEAD SCREWS (78S).
NOTE: To raise a corner of the unit, turn the ADJUSTABLE
å
GLIDE counter-clockwise. To lower a corner, turn the
ADJUSTABLE GLIDE clockwise.
Mounting
screw
Hinge
SILVER 5/8" MACHINE SCREW
(4 used for the PULLS)
BLACK 9/16" LARGE HEAD SCREW
(2 used in this step)
Page 26
Stop
149K
15S
1S
B
N
425811
E
www.sauder.com/service