STEINEL L 265 S Manual Del Usuario página 10

Serie L 265_24spr 17.07.2008
Functions , ,
Once installed, the sensor can be put into operation. Control
dials are provided on the sensor unit for selecting time, twi-
light and programme settings. After pressing the engagement
Switch-off delay
(time setting)
(factory setting: 5 sec.)
Twilight setting
(sensor response
threshold)
(factory setting: daylight operation 2000 lux)
Programme setting
(factory setting: programme 1)
The following programmes only relate to
the LED corona of light and the Power LED
effect light. Once ambient light levels reach
the twilight setting, the main light always
switches "ON" in response to movement
and "OFF" again after the selected time
setting.
AN
=
LED
ON
* Note on LED comfort economy programme
The sensor does not have any integrated clock. The middle of
the night is only determined on the basis of the length of dark-
ness phases. To work perfectly, therefore, it is important for
the light to be permanently connected to the power supply
during this period. During the first night (calibration phase) the
LEDs remain activated. Values remain saved even in the event
of mains power failure.
11:01 Uhr Seite 11
lug with a flat-bladed screwdriver, the sensor unit can be
removed for ease of setting. In this case, the SensorLight
automatically switches to constant output.
Light '"ON"' duration can infinitely varied from 5 sec. to 15 min.
Control dial set to – = shortest time (5 sec.)
Control dial set to + = longest time (15 min.)
When setting the detection zone, it is recommended to select
the shortest time –.
5 sec. – 15 min.
The sensor's response threshold can be infinitely varied from
2 – 2000 lux.
Control dial set to
Control dial set to
To adjust the detection zone in daylight, the control dial must be
set to (daylight operation).
2 - 2000 lux
Programme
LEDs "ON" from twilight setting for the whole night.
G
Programme
LEDs "ON" from twilight setting to the middle of the night.
G
The LEDs then switch "ON" in response to movement.
G
Programme
LEDs switch "ON" in response to movement.
G
LEDs go out when time setting elapses.
G
SENSOR
:
3
We recommend not to interrupt the power supply in pro-
gramme
3
the sensor should, in the event of any fault, be observed over
several nights to ascertain whether the LED switch-off time
moves towards the middle of the night.
- 10 -
= daylight operation at approx. 2000 lux.
= night-time operation at approx. 2 lux.
+ : LED comfort programme:
1 2
: LED comfort economy programme*:
3
: LED standard programme:
4
. As the values are determined over several nights,