Placing Tool In Service - Ingersoll Rand 4151 Serie Manual De Instrucciones

WARNING
Always wear eye protection
when operating or
performing maintenance
on this tool.
LUBRICATION
Ingersoll- - Rand No. 10
Every 160 hours of tool operation, remove sanding pad
from spindle and inject 1 or 2 strokes of Ingersoll- - Rand
No. 60 Grease through the end of the spindle to lubricate
the needle bearing in the counter- - balance.
Free
Model Model
Speed S
4151, 4151- - 2 12,000
4151- - HL 12,000
4151- - 5 12,000
Tested in accordance with PNEUROP PN8NTC1.2
H
♦ Tested in accordance with ISO8662- - 1
WARNING SYMBOL IDENTIFICATION

PLACING TOOL IN SERVICE

Ingersoll- - Rand No. 68
(Dwg. TPA1751)
SPECIFICATIONS
Pad Diameter
d
in mm
6 152
6 152
5 127
WARNING
Read this manual before
operating tool.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
HSound Level
dB (A)
Pressure Power
81.6 - - - - - -
81.6 - - - - - -
81.6 - - - - - -
3
Always wear hearing
protection when operating
this tool.
FILTER
COMPRESSOR
(Dwg. TPD905- -1)
Inlet
♦Vibrations
Connection
Level
Thread
2
m/s
Type
4.7 1/4" NPT
4.7 1/4" NPT
4.7 1/4" NPT
WARNING
Minimum
Inside Ø
Air Hose
Inches
(mm)
5/16 (8)
5/16 (8)
5/16 (8)