Preparing For Use; Risk Of Electric Shock; Removing, Filling, And Attaching The Water Tank - EASYHOME DM 2012 Manual Del Usuario

USA

Preparing for use

Preparing for use
WARNING!

Risk of electric shock!

Filling the water tank while it is still attached to the main unit and
not disconnected from the mains may result in electric shock.
− Before filling the water tank, turn the steam mop off and
unplug it from the mains.
NOTICE!
Risk of damage!
Turning the steam mop on when the water tank is not attached
or correctly installed may damage it.
− Before removing or attaching the water tank, turn the
steam mop off and unplug it from the mains.
− Make sure that the water tank is correctly attached and
only filled with clean water.
− Make sure the cleaning cloth is properly attached and
fastened.

Removing, filling, and attaching the water tank

Always use clean water when filling the water tank. Do not fill the tank above
the "MAX" marking.
To remove the water tank from the main unit, proceed as follows:
1. Slide the water tank
forward off the main unit
Filling the tank can be done from the tap after removing it
or, when the tank is still attached to the main unit, by using
the enclosed measuring cup and funnel. To fill the water
tank while it is still on the main unit, proceed as follows:
1. Open the water tank plug
2. Fill the measuring cup
funnel.
Repeat until the desired amount of water is in the water tank.
16
www.aldi.us
4 upwards until you can pull it
5 .
9 and insert the water tank funnel
12 with water and pour it into the water tank
4
16 .
AFTER SALES SUPPORT
1-800-886-8506
USA