Using The Steam Mop On Carpets; After Using The Steam Mop - EASYHOME DM 2012 Manual Del Usuario

For a smooth operation, we recommend that you do not activate
the steam function immediately after connecting the appliance to
the mains supply, as the temperature will not be high enough to
fully vaporize the water. Drops may form and water, not steam, will
emerge from the appliance. When the appliance is in use, to en-
sure that water drops do not form because of too much steam or
water, the appliance automatically adjusts the steam level when
the steam function is on. If, however, water drops do form during
use, we recommend that you activate the steam function for only
a brief period and then switch it off as soon the steam volume is
substantially lower. After a short time any residual water in the ap-
pliance will have sufficiently heated through and you can switch
the steam function back on. This allows for the optimum use of the
available water in relation to the surface to be cleaned.

Using the steam mop on carpets

1. Set the cleaning head
carpet glider attachment
2. With the steam function activated as needed,
push and pull the cleaning head carefully over the
surface to be cleaned, including the corners.
3. To stop the outflow of steam, press the steam trigger
again.

After using the steam mop

1. Switch the steam function off.
2. Disconnect the steam mop from the mains by pulling the plug out of the
socket.
3. Let the steam mop cool to room temperature before installing or removing
accessories, cleaning or storing it.
4. Empty the water tank
5. Wrap the power cord around the cord wrap
upright in a dry place.
AFTER SALES SUPPORT
1-800-886-8506
USA
7 of the steam mop into the
.
11
and remove the cleaning cloth
4
Using the steam mop
11
8
10 and store the steam mop
USA
.
19
www.aldi.us