Product Specifications; Unpacking - Delta 28-400 Manual De Instrucciones

Motor
Cutting Capacity - Height
Cutting Capacity - Width
Minimum Blade Width
Maximum Blade Width
Blade Length
Blade Speed - Low
Blade Speed - High
Table Size
Table T-Slot Size (DxW)
Table Height From Floor
Table Tilt
Dust Port Diameter
Overall Dimensions (HxWxD)
Net Weight
Shipping Weight
Carefully unpack the machine and all loose items from the shipping container(s). Remove the rust-preventative oil
from unpainted surfaces using a soft cloth moistened with mineral spirits, paint thinner or denatured alcohol.
Do not use highly volatile solvents such as gasoline, naphtha, acetone or lacquer thinner for cleaning your machine.
After cleaning, cover the unpainted surfaces with a good quality household floor paste wax.
NOTICE: The manual cover illustrates the current production model. All other illustrations contained in the manual
are representative only and may not depict the actual labeling or accessories included. These are intended to
illustrate technique only.
The machine is heavy, be careful when removing it from the shipping container! Failure to comply
may cause serious injury and/or damage to the sander and/or property!
Your DELTA ® 14" Steel Frame Band Saw comes packed in a single container. Use a safety strap to avoid tip-over
when lifting machine. Check shipping carton and machine for damage before unpacking.
Open the shipping container. Carefully remove packaging materials, parts and machine from shipping carton. Always
check for and remove protective shipping materials around motors and moving parts. Lay out all parts on a clean
work surface and check that all parts are present and in good condition:
dESCRIPTION (QUANTITY)
• Stand Legs (4)
• Bottom Stand Braces (4)
• Stand Top (1)
• Stand Hardware Pack (1)
• Cast Iron Work Table (1)
• Top Trunnion (1)
• 93 ½" Band Saw Blade (1)
• Blade Tensioning Handle (1)
• Throat Plate (1)
• Hardware Pack (1)

PROdUCT SPECIFICATIONS

UNPACkINg

CONTENTS OF STANd
hARdwARE PACk
• M6 X 16 Carriage Bolts (24)
• M6 FLAT Washers (24)
• M6 HEX Nuts (24)
• Rubber Feet (4)
1 HP, 120V
6"
13-5/8"
1/8"
3/4"
93-1/2"
1620 ft./min (490m/min.)
3340 ft./min (990m/min)
15-3/4" X 18-7/8"
3/8" X 3/4"
40-3/4"
3° left - 45° right
4"
27" X 19" X 65-1/2"
180 Lbs.
165 Lbs.
CONTENTS OF TOOL
hARdwARE PACk
8
• M8 X 20 Hex Bolts (8)
• M6 Lock Washers (4)
• M6 Flat Washers (4)
• (size) Trunnion Feed Bolt (1)
• 8MM Flat Washer (1)
• Table Tilt Locking Wing Nut (1)
• M8 Flat Washers (4)
• M8 Lock Washers (4)
• M8 Hex Nuts (4)