Assembly And Adjustment - DeWalt DW882 Traducido De Las Instrucciones Originales

Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
machine (see technical data). The minimum
conductor size is 1.5 mm
always unwind the cable completely.
Also refer to the table below.
Conductor size (mm 2 ) Cable rating (Amperes)
0.75
1.00
1.50
2.50
4.00
Cable length (m)
7.5
Voltage Amperes Cable rating (Amperes)
230 0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
Voltage drops
Inrush currents cause short-time voltage drops.
Under unfavourable power supply conditions, other
equipment may be affected.
If the system impedance of the power supply is lower
than 0.25 ø, disturbances are unlikely to occur.

Assembly and adjustment

Prior to assembly and adjustment always
unplug the tool.
Mounting an accessory (fig. B)
• Slacken the wingnuts (5) and swivel the bolts (6)
to release the cover (7).
• Open the cover.
• Hold the spindle by inserting the Allen key into
one of the holes in the inner flange.
• Loosen the nut (8) using the spanner. Remove
the nut and the outer flange (9).
• Mount the accessory (10) on the spindle.
• Replace the flange and securely tighten the nut.
• Close the cover and lock it by tightening the
wingnuts.
14
2
. When using a cable reel,
6
10
15
20
25
15 25 30 45
6 6 6 6 6
6 6 6 6 6
6 6 6 6 10
10 10 10 10 15
15 15 15 15 20
20 20 20 20 25
• To remove the accessory, proceed in reverse
order.
Mounting and removing the guard (fig. C)
• Remove the accessory as described above.
• Loosen the bolts (11).
• Slide the guard onto the tool as shown.
• Securely tighten the bolts.
• To remove the guard, proceed in reverse order.
Never operate the tool without the guard,
except when polishing using a cloth disc.
Mounting the front handle (fig. D)
• Screw the front handle (3) tightly into the hole (12).
60
Instructions for use
6
• Always observe the safety instructions
6
and applicable regulations.
15
• Ensure all materials to be ground, cut or
15
polished are secured in place.
20
• Apply only a gentle pressure to the tool.
-
Do not exert side pressure on the
grinding, cutting or polishing accessory.
• Avoid overloading. Should the tool
become hot, let it run a few minutes
under no load condition.
Prior to operation:
• Install the appropriate accessory. Do not use
excessively worn accessories.
Switching ON and OFF (fig. E)
• To run the tool, press the ON/OFF-switch (1).
• For continuous operation, first release the release
button (2) and then release the ON/OFF-switch.
• To stop the tool, press the release button and
release the ON/OFF-switch.
Holding the tool
• Always hold the tool with both hands.
Consult your dealer for further information on the
appropriate accessories.
E N G L I S H
en - 4