Assembly And Adjustment - DeWalt DW849 Manual De Instrucciones

E N G L I S H
The wires are coloured according to the following code:
live = brown
neutral = blue
• Do not connect the blue or brown wire to the
earth terminal in the plug.
Connect as follows:
brown to terminal marked 'L'
blue to terminal marked 'N'
The plug fitted should be comply with BS EN 60309
(BS4343), 32 Amps.
Always ensure that the cable clamp is
correctly and securely fitted to the
sheath of the cable.
Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor
size is 1.5 mm 2 . When using a cable reel, always
unwind the cable completely.
Also refer to the table below.
Conductor size (mm 2 ) Cable rating (Amperes)
0.75 6
1.00 10
1.50 15
2.50 20
4.00 25
Cable length (m)
7.5
Voltage Amperes Cable rating (Amperes)
115 0 - 2.0 6
2.1 - 3.4 6
3.5 - 5.0 6
5.1 - 7.0 10
7.1 - 12.0 15
12.1 - 20.0 20
230 0 - 2.0 6
2.1 - 3.4 6
3.5 - 5.0 6
5.1 - 7.0 10
7.1 - 12.0 15
12.1 - 20.0 20
en - 4
15 25 30 45 60
6 6 6 6 10
6 6 6 15 15
6 10 15 20 20
10 15 20 20 25
15 20 25 25 -
20 25 - - -
6 6 6 6 6
6 6 6 6 6
6 6 6 10 15
10 10 10 15 15
15 15 15 20 20
20 20 20 25 -

Assembly and adjustment

Prior to assembly and adjustment always
unplug the tool.
Mounting the side handle (fig. B)
• Screw the side handle (5) tightly into one of the
holes on either side of the tool.
Fitting and removing the backing pad (fig. C)
• Place the tool on a table, spindle up.
• Press the spindle lock (4) and turn the spindle
until the lock engages.
• Place the backing pad (6) onto the spindle.
• Screw the threaded flange (7) onto the spindle.
• Tighten the threaded flange.
• Release the spindle lock.
• To remove the backing pad, loosen the threaded
flange while the spindle lock is engaged.
Fitting the polishing bonnet (fig. D)
• Place the tool on a table, spindle up.
• Pull the polishing bonnet (8) over the backing
pad (6).
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Apply only a gentle pressure to the tool.
Do not exert side pressure on the
backing pad.
• Avoid overloading. Should the tool
become hot, let it run a few minutes
under no load condition.
Prior to operation:
• Be sure the threaded flange is mounted correctly.
• Make sure the pad rotates in the direction of the
arrows on the accessory and the tool.
• Make sure any dirt is washed off the workpiece
surface.
Polishing (fig. A)
• Always use clean polishing bonnets.
• Evenly apply a required amount of polishing
paste over the polishing bonnet.
• Hold the polishing bonnet to the surface to be
polished and switch on the tool.
15