Delivery Scope - Brita PURITY 450 Quell ST Manual De Instrucciones

4 Installation
Caution: Prior to installation, read the Technical Data (Chapter 12) and the Operating and Safety
!
Information (Chapter 3). After the product has been stored and transported at temperatures below
0°C, it must be stored with the original packaging open for at least 24 hours before commissioning.

4.1 Delivery Scope

For installation of a PURITY Quell ST new fi lter, you need the packaging units pressure vessel
(incl. fi lter cartridge) and pressure vessel lid
Prior to installation, remove the entire delivery scope from the packaging and check that everything
is present:
1 x Pressure Vessel
1
1 x Pressure Vessel Lid
1 x Filter Cartridge
2
1 x Manual
1 x Carbonate Hardness Test
If part(s) of the delivery scope are missing, please contact your local BRITA Offi ce.
4.2 Assembling the Pressure Vessel and the Pressure Vessel Lid
•
•
•
•
•
•
•
•
•
4.3 Assembly of Inlet and Outlet Hoses (e.g. coffee machine)
Note: The inlet and outlet hoses are not included in the standard scope of delivery. The use of
BRITA hose sets (Chapter 12) or hoses according to DVGW W543 is recommended. The fl ush valve
supplied ensures that the hose to the consumer (e.g. coffee machine) is closed in the fl ush posi-
9
tion.
• Fit hoses to the inlet and outlet of the pressure vessel lid
inlet and outlet are seated correctly.
Note: No additional use of fl at seals is necessary.
Caution: The max. tightening torque at the 1" and 3/4" connections must not exceed
!
15 Nm! When using hoses not made by BRITA make sure that only connections with fl at seals
are used. Conical seal shapes damage the fi lter head connections and invalidate any guarantee
claims. The fl ow direction indicated by the arrows on the connector head
During assembly, comply with the installation dimensions (Chapter 11), bending radii of the
hoses and dimensions of the accessories (e.g. hose sets). The system can be operated verti-
cally and horizontally. Use the wall mounting (Chapter 12) to install the system in a vertical posi-
tion only! If no original BRITA hose sets are used, the 1" – 3/4" reducer
to ensures correct sealing of the non-return valve.
3
Stand on the kick loops
Lift the pressure vessel
over the kick loops .
12
Remove the transport protective cap
Check the O-ring seal of the fi lter cartridge
and for dirt and damage.
Note: The cartridge seat has been lubricated with food-safe lubricant at the
factory.
Stand on the kick loops
Place the pressure vessel lid
vessel with the lock
1
Press the pressure vessel lid
engages.
Push the fl ush hose
21
.
3
.
12
and turn clockwise until the mantle handles
1
from the fi lter cartridge.
18
.
12
in the position "INSERT" on the pressure
3
in the appropriate groove.
15
down and turn clockwise until the lock
3
onto the fl ush valve
. Ensure that the O-rings on the
3
for correct seat in the groove
2
.
9
must be observed.
4
supplied must be used
17
1
are
16
23