After Use; Cleaning And Maintenance - Boneco V2231 Manual De Instrucciones

Turning the device on
• Insert plug into mains socket.
• Use the ON/OFF switch to turn the device on.
en
C
B
A
A) ON/OFF switch with control display
• Blue LED is illuminated when device is switched on.
B) Setting switch for two levels with
LED displays:
« » High performance for daytime operation
(blue LED illuminated)
« » Low performance for night time operation
(green LED illuminated)
C) Regulator for integrated humidistat
• Use the rotary switch to adjust the built-in humidistat.
This monitors the humidity. The adjustment range is
20 – 90% relative humidity.
• The recommended comfort zone is indicated by
white dots.
14

After use

• Use the ON/OFF switch to turn the device off.
• Remove the plug from the mains socket.
• Wait until the device has cooled fully.
• Empty any remaining water and rinse the water tank
thoroughly.
Clean and maintain the device regularly to ensure that it
operates hygienically and smoothly.
• Weekly: Clean housing parts and water tank.
• Depending on quantity of limescale: descale
Magic Ball and evaporator board (see «Cleaning and
maintenance»).
• Annually: clean the device after the heating season.
• Ensure the device is allowed to dry fully before putting
it into storage.

Cleaning and maintenance

Remove the plug from the mains before cleaning,
maintaining, descaling or rinsing the device.
• Allow the device to cool fully.
• Never immerse the basic device (including the cable) in
water or any other liquid.
• Empty any remaining water from the device and water
tank and rinse the water tank thoroughly.
• Lift up the evaporator unit cover to remove it
• The Magic Ball absorbs a large proportion of the
limescale particles. It hinders calcification by moving
across the evaporator board. Depending on the level
of limescale, the Magic Ball needs to be cleaned at
regular intervals (immerse the Magic Ball completely in
limescale-remover).
• The evaporator board also needs to be descaled on
a regular basis. Creates steam when in operation.
Warning! Hot! If limescale deposits form around the
evaporator board, descale the device with domestic
limescale-remover (mixing ratio limescale-remover:
water = 2:1). To do so, apply limescale-remover to the
black board (avoiding any plastic components!). After
the limescale remover has taken effect, use a cloth
to remove any residue and then wipe the board dry.
Important: do not use any abrasive implements (knives
etc.) or scouring pads as this damages the non-stick
coating!
• Clean the housing with a damp cloth then wipe it dry.
Notes on how an evaporator-humidifier
works
• In the evaporator principle, water is made to evaporate
on the evaporator board.
• Humidity is monitored by the built-in humidistat.
• Humidity is heavily restricted by circulating air
(for example, in rooms with open/poorly sealed
windows or in elevated rooms).
• Please note that humidity increases as air temperature
rises and this can cause unwanted condensation in
some areas.
Recommended values for humidity
in living space
Room temperature Relative Humidity
18 °C 50 %
20 °C 45 %
22 °C 40 %