Briggs & Stratton 2691691-00 Manual Del Operario página 7

A Decal, Main Safety
Part No. 5106566
B Decal, Danger, Thrown
Objects
Part No. 7106109
Safety Decal Icon Definitions
A WARNING: Read and understand the Operator's Manual before
using this machine. Know the location and function of all controls.
Do not operate this machine unless you are trained.
B DANGER - AMPUTATION AND DISMEMBERMENT HAZARD: To
avoid injury from rotating blades and moving parts, keep safety
devices (guards, shields and switches) in place and working.
C DANGER - THROWN OBJECTS AND AMPUTATION
HAZARD: To avoid injury, keep bystanders and children away.
Remove objects that can be thrown by the blades. Do not mow
without discharge chute or entire grass catcher in place.
D DANGER - LOSS OF CONTROL AND ROLL OVER
HAZARD: Operating on slopes can be hazardous and cause a
loss of control and roll-overs. Do not operate on slopes over 10*
degrees. Avoid sudden turns or rapid speed changes. Reduce
speed and use extreme caution on slopes. Avoid turning down
slopes; if possible, turn up slopes. Do not operate down slopes
towards or near water, retaining walls, or drop-offs. Give yourself a
minimum of two mower widths of clearance around these hazards.
E DANGER - AMPUTATION HAZARD: Never carry riders, especially
children, even with the blades off. Do not mow in reverse unless
absolutely necessary. Look down and behind - before and while
backing.
F DANGER: LOSS OF TRACTION, SLIDING, STEERING, AND
CONTROL ON SLOPES HAZARD: If machine stops forward
motion on a slope, stop the blades. and drive slowly off the slope.
G DANGER: Engage parking brake, remove key, and consult
technical literature before performing service or maintenance.
H DANGER - FIRE HAZARD: Remove key and wait three (3) minutes
before refueling.
I DANGER - THROWN OBJECTS HAZARD: Do not mow without
discharge chute or entire grass catcher in place.
J DANGER - THROWN OBJECTS AND AMPUTATION
HAZARD: To avoid injury from rotating blades, stay clear of deck
edge and keep others away.
*This limit was determined per International Standard ISO 5395-3:2013,
Section 4.6 and is based on the ISO 5395-3 Stability Test procedure
described in Annex A. The 10 degree "limit of stability" is equal to 60%
of the angle at which machine lift-off occurred in static tests. Actual
dynamic stability may vary depending on operating conditions.
7